C8051T630DK Silicon Laboratories Inc, C8051T630DK Datasheet - Page 2

• Manufacturer Part Number: C8051T630DK
• Description: KIT DEV FOR C8051T630 FAMILY
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051T630DK

• Contents: Board, daughter boards, power adapter, cables, documentation and software
• Processor To Be Evaluated: C8051T63x
• Interface Type: USB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: C8051T630, T631, T632, T633, T634 and T635 MCUs
• For Use With: 336-1465 - BOARD SOCKET DAUGHTER 20-QFN
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1464

C8051T63x-DK
3. Hardware Setup
See Figure 1 for a diagram of the hardware configuration.
1. Attach the desired daughter board to the motherboard at connectors P1 and P2.
2. If using the QFN Socket Daughter Board, place the device to be programmed into the socket.
3. Place shorting blocks on J7 and the +3VD-VDD_PWR jumper pair on J6, as shown in Figure 1.
4. Connect the motherboard’s P5 USB connector to a PC running the Silicon Laboratories IDE using the USB
5. Connect the ac-to-dc power adapter to connector P3 on the motherboard.
Notes:
2
Cable.
•
•
•
•
Use the Reset icon in the IDE to reset the target when connected during a debug session.
Remove power from the motherboard and remove the USB cable before removing a daughter board from the
motherboard. Connecting or disconnecting a daughter board when the power adapter or USB cable are connected can
damage the motherboard, the daughter board, or the socketed device.
Remove power from the motherboard and remove the USB cable before removing a C8051T63x device from the socket.
Inserting or removing a device from the socket when the power adapter or USB cable are connected can damage the
motherboard, the daughter board, or the socketed device.
The above hardware setup instructions configure the development system to be powered through the onboard 3.3 V
regulator. For other power options, see Section 7.3.
C8051T630 EDB
R8
SILICON LABS
J4
www.silabs.com
J2
F336
J3
J12
J5
J13
P4
Figure 1. Hardware Setup (Emulation Daughter Board)
P1
P2
PWR
USB ACTIVE
SW
COMM
LED
SW
RTS_CP2103
J9
RX_CP2103
RTS_F326
RX_F326
P1.3
P0.7
VPP
P1.1
P0.4
D7
J11
J10
J8
VDD_CCP2103
C8051T630-MB
CTS_F326
CTS_CP2103
P1.2
TX_F326
TX_CP2103
P0.5
VDD_F326
VDD_EXT
Rev. 0.1
D10
+3VD
RUN / STOP
J6
D11
J7
P5
VDD_PWR
VDD_PWR
VDD_PWR
VDD_PWR
PWR
RESET
P3
DEBUG
D12
DEBUG
PWR
Place shorting blocks on
J7 and J6 as shown.
USB Cable
AC Adapter