STM8L15LPBOARD STMicroelectronics, STM8L15LPBOARD Datasheet - Page 6

• Manufacturer Part Number: STM8L15LPBOARD
• Description: DEM FOR STM8L15X LOW PWR MODES
• Manufacturer: STMicroelectronics
• Series: STM8L EnergyLiter
• Type: MCUr

Specifications of STM8L15LPBOARD

• Contents: Board
• Processor To Be Evaluated: STM8L15x
• Processor Series: STM8
• Data Bus Width: 8 bit
• Operating Supply Voltage: 5 V
• Core Architecture: STM8
• Core Sub-architecture: STM8
• Silicon Core Number: STM8
• Features: SWIM Debug Support, MCU Consumption Auto Measurement Circuit, MCU Pins Connector
• Silicon Manufacturer: ST Micro
• For Use With/related Products: STM8L15x
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-10594

Overview
2.7
6/9
MCU consumption auto-measurement circuit (JP1)
For IDD measurement the circuit below is implemented on the STM8L15LPBOARD. This
circuit requires jumper JP1 to be connected between pins 2 and 3.
Figure 4.
Table 3.
In Run mode, IDD current is measured by MAX9938FEUK+ (U1) connected to the 2 ohm
shunt resistor. In this case ICC_CNT_EN remains high during measurement.
In Halt mode, the operational amplifier MAX9938FEUK+ (U1) is connected to the 2 Kohm
shunt resistor. To measure a current corresponding to the Halt mode the procedure is:
1.
2.
3.
4.
5.
6.
In Halt mode, the 2 K resistor is connected when T3 goes off after entering Halt mode.
The Q12 counter output allows connection of the 2 K resistor when the current ICC
becomes very low.
The Halt mode measurement procedure can be used in Low power modes if the IDD current
does not exceed 12 uA; otherwise the Run measurement procedure must be used up to
12 mA.
ICC_Measurement
ICC_WAKEUP (on rising edge)
ICC_CNT_EN (active low)
Configure ADC to measure voltage on the ICC_measurement pin.
Configure ICC_WAKEUP as interrupt input on rising edge.
Enter in Halt or Active Halt mode with ICC_CNT_EN low.
ICC_WAKEUP rising edge wakeup the MCU after 300 ms.
start ADC conversion as soon as possible after wakeup in order to measure the voltage
corresponding to Halt mode on 1 uF capacitor C1.
Reset the counter by programming ICC_CNT_EN High to avoid 2 Kohm to be
connected later on VDD_MCU.
IDD measurement circuit
IDD measurement circuit pinout
Signal
Doc ID 16160 Rev 2
PF0
PA3
PA2
Pin
STM8L15LPBOARD