SOT23-5EV-VREG Microchip Technology, SOT23-5EV-VREG Datasheet - Page 10
![EVAL BOARD SOT23-5 VOLTAGE REG](/photos/24/8/240804/4683012_sml.jpg)
SOT23-5EV-VREG
Manufacturer Part Number
SOT23-5EV-VREG
Description
EVAL BOARD SOT23-5 VOLTAGE REG
Manufacturer
Microchip Technology
Datasheet
1.SOT23-5EV-VREG.pdf
(24 pages)
Specifications of SOT23-5EV-VREG
Channels Per Ic
1 - Single
Regulator Type
Positive Fixed & Adjustable
Board Type
Partially Populated
Utilized Ic / Part
SOT-23-5 Package
Silicon Manufacturer
Microchip
Application Sub Type
Voltage Regulator
Kit Application Type
Power Management - Voltage Regulator
Silicon Core Number
MCP1801, MCP1802, TC1014/1015/1185
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Current - Output
-
Voltage - Output
-
Voltage - Input
-
Operating Temperature
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
SOT23-5 Voltage Regulator Evaluation Board User’s Guide
DS51811A-page 6
1.2.2
Jumper JP1 connects the input capacitance to the circuit. The input capacitor is
disconnected when performing Power Supply Ripple Rejection tests. By default, C1 is
populated with a 1 µF, 50V, XR7 ceramic capacitor.
1.2.3
Jumper JP2 allows the user to select the Shutdown (SHDN) pin voltage level. The
voltage level may be set to V
jumper. When the jumper is not connecting pins 1 and 2 or pins 2 and 3 of JP2, the
voltage level may be set by attaching a signal to TP5. This allows the user to enable,
disable or pulse the shutdown pin of the device.
The board comes with R1 populated with a 10 kΩ resistor.
1.2.4
Jumper JP3 allows measurement of ground current. When a current meter is
connected to TP6 and TP7 and jumper JP3 is removed, the ground current of the
device may be measured.
1.2.5
For Adjustable Output Voltage devices, R2 and R3 may be populated with appropriate
values to provide the desired output voltage.
The board comes with R2 populated with a 69.8 kΩ resistor.
1.2.6
For devices with a Power Good (PWRGD) output, either R2 or R4 is populated
depending on the desired pull-up source voltage.
R2 selects V
R4 selects V
The board comes with R2 populated with a 69.8 kΩ resistor.
1.2.7
R5 may be populated with the desired load resistor values for the device being
evaluated. Jumper JP4 connects R5 to the device output.
1.2.8
C2 may be populated with the desired output capacitance. By default, C2 is populated
with a 1 µF, 6.3V, XR7 ceramic capacitor.
1.2.9
C3 may be populated with the desired bypass capacitance.
1.2.10
J1 or TP1 and TP2 are connected to the user’s power supply.
Input Capacitance
Shutdown Control
Ground Current Measurement
Voltage Adjust
Power Good (PWRGD)
Load Resistor
Output Capacitor
Bypass Capacitor
Power Supply
OUT
IN
as the pull-up source voltage.
as the pull-up source voltage.
IN
, GND or open, depending on the placement of the JP2
© 2009 Microchip Technology Inc.