SI3056PPT2-EVB Silicon Laboratories Inc, SI3056PPT2-EVB Datasheet - Page 6

• Manufacturer Part Number: SI3056PPT2-EVB
• Description: BOARD EVAL FOR DAA SI3056/SI3010
• Manufacturer: Silicon Laboratories Inc

Specifications of SI3056PPT2-EVB

• Main Purpose: Telecom, Data Acquisition Arrangement (DAA)
• Utilized Ic / Part: Si3056
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Secondary Attributes: -
• Embedded: -
• Primary Attributes: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Si30xxPPT-EVB
RX Control
!
!
!
!
Dialer
!
!
Measurement
!
!
!
!
!
6
Monitor Mode: Allows the selection of several data
modes. Digital Loopback mode routes the DAC data
back to the receive path. On-hook mode configures
the DAA to the on-hook mode. Off-hook mode
configures the DAA to the off-hook mode. On-hook
line monitoring mode configures the DAA to the line
monitoring state.
RX Gain/Attn (dB): Selects the receive path gain/
attenuation.
RX Mute: Mutes the receive path
Ring Detect Mode: Allows selection of full-wave or
half-wave ring detection.
Dial Number: Inputs dial number.
Dial: Executes dial.
Loop Current: Displays the loop current when in off-
hook mode.
Ring Detect Bits: Displays the state of the ring
detect bits when in on-hook mode.
Off-Hook: Indicates that the DAA is in the off-hook
state.
DC Level/SINAD: Displays either the dc level of the
time domain waveform or the SINAD of the
frequency domain waveform.
RMS Level/Frequency: Displays either the RMS
level of the time domain waveform or the frequency
of the largest peak in the frequency domain
waveform.
Preliminary Rev. 1.0
!
Wave Display Controls
!
!
!
!
!
!
!
!
Num Avg for FFT: When in FFT display, the
software automatically averages waveforms. This
panel selects the number of averages to take.
Display Type: Selects how the ADC data is
displayed on the Waveform Graph (time or
frequency domain).
Amplitude Units: Sets the amplitude units for the
Waveform Graph and Amplitude control to either
volts or codes.
Acquisition: Used to run or pause the CODEC data
stream. Upon pausing the acquisition of the data, it
displays measurement values regardless of the
status of “display measurement” under the configure
menu.
X Autoscale: Automatically scales the X-axis of the
graph to fit the entire waveform.
Y Autoscale: Automatically scales the Y-axis to fit
the entire vertical range of the waveform.
Xmin: Sets the origin of the X-axis when the X
Autoscale is disabled.
X Zoom: Used to zoom a portion of the displayed
waveform when X Autoscale is disabled. The
waveform starts at Xmin and 1/X Zoom of the total
waveform is displayed.
Yo: Sets the origin of the Y-axis when Y Autoscale is
disabled. Half of the waveform is displayed above
Yo, and half is displayed below Yo.