SI3056PPT2-EVB Silicon Laboratories Inc, SI3056PPT2-EVB Datasheet - Page 4

• Manufacturer Part Number: SI3056PPT2-EVB
• Description: BOARD EVAL FOR DAA SI3056/SI3010
• Manufacturer: Silicon Laboratories Inc

Specifications of SI3056PPT2-EVB

• Main Purpose: Telecom, Data Acquisition Arrangement (DAA)
• Utilized Ic / Part: Si3056
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Secondary Attributes: -
• Embedded: -
• Primary Attributes: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Si30xxPPT-EVB
Evaluation Software
The Si30xxPPT-EVB includes an easy-to-use graphical
interface for controlling the evaluation platform. This
software allows the system designer to characterize the
Si30xx DAA performance without constructing any
custom hardware. The evaluation software includes the
following features:
!
!
!
!
!
!
!
PC System Requirements
The application software for the Si30xxPPT-EVB has
the following system requirements:
!
!
!
!
Installation
The supplied CD contains the Si30xxPPT-EVB windows
driver files as well as a setup utility for installing the
evaluation software.
To install the Si30xxPPT-EVB software, run the
installation program on the “Silicon Laboratories
Wireline Software CD.” The path for the installation
program is Si30xx Evaluation Software\setup.exe. The
installer guides the user through the installation process
for Si30xxPPT-EVB.exe and the LabVIEW Run-Time
engine.
Using the Si30xxPPT-EVB
Application Software
A shortcut for starting the application software that
controls the Si30xxPPT-EVB is installed in the Windows
Start Menu under the Programs folder in the “Si30xx
Evaluation Software” folder.
Application Menus
Three pulldown menus are used to configure the
operation of the software:
4
Ability to read and write DAA registers using the SSI
bus
DAC waveform generation from a series of standard
waveforms or from a .wav file
ADC data capture and display in either time or
frequency domain using the SSI bus
Daisy-chain support
Transmit and receive path attenuation and gain
settings
Ring detection
Loop current measurement
Windows98 or Windows2000
Available parallel port
"
"
450 MHz Pentium II or greater recommended
64 MB of memory or greater recommended
EPP or ECP parallel port mode for Windows 98
EPP parallel port mode for Windows 2000
Preliminary Rev. 1.0
!
!
!
!
Run:
"
"
Configure:
"
configuration. User can set advanced software options.
"
initialization sequences on Reg 1, Reg 6–10, and Reg 14.
Design Tool
"
"
Si30xx.
"
over frequency
"
Help: Displays information about the evaluation
board
Transhybrid Loss Calculation: Calculate transhybrid loss
Exit: Stops the program
Save: Stores the audio waveform into .wav files
Configure DAA: Display hardware status and user
Reset DAA: Resets DAA and executes basic
Register Map: Displays Register Map of Si30xx
Signal Flow Diagram: Displays Signal Flow Diagram of
Ringing: Helps user program ring validation registers.