STEVAL-IPE008V1 STMicroelectronics, STEVAL-IPE008V1 Datasheet - Page 9

• Manufacturer Part Number: STEVAL-IPE008V1
• Description: BOARD EVAL STPM01/STR715FR0
• Manufacturer: STMicroelectronics
• Type: Other Power Managementr

Specifications of STEVAL-IPE008V1

• Main Purpose: Power Management, Energy/Power Meter
• Embedded: Yes, MCU, ARM7
• Utilized Ic / Part: STPM01, STR715FR0
• Primary Attributes: 3-Ph Energy Meter (or Single Phase)
• Secondary Attributes: Measures Active, Reactive, Apparent Power
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: STPM01, STR715FR0
• Other names: 497-6412; STEVAL-IPE008V1

STPM01
4
Table 5.
Programmable
SCLNLC
SDATD
MON
MOP
SYN
SCS
LED
pin
Functions
Programmable pin functions
Output for Stepper’s node (MB)
Output for Stepper’s node (MA)
If APL=2 then LED provides high frequency
pulses proportional to Active Energy with 50%
duty cycle.
If APL=3 then LED provides pulses proportional
to Active Energy (internal signal AW). The
number of pulses per kWh can be selected
according to the value of KMOT configuration bit.
No-load indicator:
when low, a no-load condition is detected
Tamper indicator:
when low tamper condition is detected
Negative active power indicator:
when low a negative active power condition is
detected
Must be high to activate SCLNLC, SDATAD and
SYN indications
(APL register=2 or 3)
Stand-alone mode
Doc ID 10853 Rev 7
If APL=0 then Watchdog signal.
If APL=1 then ΔΣ signal of current channel
If APL=0 then ZCR
If APL=1 then ΔΣ signal of voltage channel
If APL=0 then LED can provide Active,
Reactive or Apparent Energy according to
value of KMOT configuration bit.
If APL=1 then LED is connected to the MUX
signal generated from the tamper detection
circuit.
When LED=low then the primary current
channel is selected, if LED=high the
secondary current channel is selected.
Used for SPI interface (see SPI interface
section for details)
(APL register=0 or 1)
Peripheral mode
Functions
9/60