Z0221500ZCO Zilog, Z0221500ZCO Datasheet - Page 30

• Manufacturer Part Number: Z0221500ZCO
• Description: Z02215 ONE-CHIP MODEM EVAL KIT
• Manufacturer: Zilog

Specifications of Z0221500ZCO

• Main Purpose: Telecom, Modem
• Utilized Ic / Part: Z02215
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Secondary Attributes: -
• Embedded: -
• Primary Attributes: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Setup and Installation
Ending A Session
2. Type
This step displays the country profile being used. This step is not required
to start a session.
3. Type the following to the modem command line to start dialing into
The Z02215 Modem Evaluation Board can be used to dial any other
remote modem with
any outgoing calls, the command is
example above.
4. Wait for 5-10 seconds for the remote modem to answer. When the
If the remote modem is BUSY, it echoes a BUSY. Try again until a con-
nection is achieved. Refer to Chapter 3 for interpreting any other result
codes.
5. The modem is now in the ON-LINE mode, connected to the remote
The modem may be instructed from the terminal program to disconnect.
To disconnect the data connection, the modem must be brought from
DATA mode to COMMAND mode by typing the Escape Sequence.
configuration of the firmware being used. This command returns this
result:
ZiLOG/Softart V.22bis Modem Control for North
America
OK
the BBS (1-408-292-0522).
ATDT9,14082920522<CR>
connection is established, the modem answers:
CONNECT 2400
modem at a data rate of 2400 bps. At this point, the modem can
communicate with the remote modem and exchange data.
ATI4<CR>
ATDT<number>
PRELIMINARY
to the modem command line to check the country
Evaluation Board User Manual
ATDT9,<number>
. If a 9 must be dialed before making
Z02215 Single-Chip Modem
, as shown in the
UM002304-0802
24