CY8CKIT-006 Cypress Semiconductor Corp, CY8CKIT-006 Datasheet - Page 48

• Manufacturer Part Number: CY8CKIT-006
• Description: KIT DEV PSOC3 LCD SEGMENT
• Manufacturer: Cypress Semiconductor Corp
• Series: PSOC™ 3r

Specifications of CY8CKIT-006

• Main Purpose: Displays, LCD Display
• Embedded: Yes, MCU, 32-Bit
• Primary Attributes: 448 addressable segments
• Secondary Attributes: Configurable LCD pin selection
• Description/function: Evaluation Kit
• Interface Type: USB
• Backlighting: No Backlighting
• Data Bus Width: 8 bit, 16 bit, 32 bit
• Maximum Operating Temperature: + 50 C
• Minimum Operating Temperature: 0 C
• Number Of Segments: 7
• Operating Supply Voltage: 12 V
• Operating Voltage: 3.3 V
• Pixel Format: 16 x 28
• Product: Display Modules
• Software: Software Included
• Touch Panel: No Touch Panel
• For Use With/related Products: PSoC 3
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Utilized Ic / Part: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 428-2994

Firmware
5.3.8.3
5.3.9
5.3.9.1
48
Pixel Only Mapped Icons
The following icons are only mapped for use as direct pixels:
■
■
■
■
■
■
■
■
■
These icons can be turned on and off directly by using the pixel writing API calls.
Digital I/O
Sleep Button
The sleep button is configured to generate an interrupt on both edges of a button press. The default
Built-In settings are used.
If the project is in wake mode, when the button is pressed and released, the button ISR signals a go
to sleep command.
If the project is in sleep mode, when the button is pressed, a wake signal is sent and the code
returns to normal flow just after the sleep entry point.
Note In sleep mode, the PSoC 3 device does not go into sleep; the firmware is just put in a lower
power mode. In the low power mode, only RTC component is left running and all other components
are powered off. It periodically wakes up the PSoC enough to strobe the ZZZ icon on and off to indi-
cate that the device is in low power mode. To know details on low power operation mode refer to
Power Entry on page
When the project is powered from a wall supply and the operator is in the RTC/TEMP submenu, then
the sleep entry is blocked. If the project is battery powered, there is no sleep blocking.
BELL (Z6)
MAX (MAX)
AM (AM)
PM (PM)
Small '1' Icon (Z1)
Small decimal point 1 (Z2)
Small decimal point 2 (Z3)
Small decimal point 3 (Z5)
Small colon (Z4)
CY8CKIT-006 PSoC 3 LCD Segment Drive Evaluation Kit Guide, Doc. # 001-52798 Rev. *C
64.
Low
[+] Feedback