STEVAL-TLL005V1 STMicroelectronics, STEVAL-TLL005V1 Datasheet - Page 7

• Manufacturer Part Number: STEVAL-TLL005V1
• Description: BOARD EVAL PWR FLASH STCF03/ST7
• Manufacturer: STMicroelectronics

Specifications of STEVAL-TLL005V1

• Design Resources: STEVAL-TLL005V1 Bill of Materials
• Main Purpose: Lighting, Camera Flash
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: STCF03
• Primary Attributes: Camera Flash, I2C Controlled, Flash and Torch Mode
• Secondary Attributes: Li-Ion Battery, Battery Charger Circuit, GUI
• Description/function: Flash Driver Evaluation Board
• Core Chip: STCF03
• Topology: Buck-Boost
• No. Of Outputs: 1
• Dimming Control Type: I2C
• Development Tool Type: Hardware - Eval/Demo Board
• Supported Devices: STCF03 Device Type
• For Use With: 497-8431 - BOARD EVAL FLASH DRIVER STCF03
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: STCF03, ST7
• Other names: 497-8207

UM0682
4
4.1
4.2
Note:
Note:
PIR sensor
The PIR sensor detects nearby motion and provides the signal to the microcontroller.
Activating the PIR sensor
The PIR sensor is activated by performing the following, in sequence:
1.
2.
3.
4.
Deactivating the PIR sensor
The PIR sensor is deactivated by removing the jumper from J3.
PIR is not mounted on the board.
when RESET switch is pressed then the GUI should be in “Close Connection Mode”.
Program the required pattern using the "Programme PIR" button on the GUI.
Place a jumper in J3.
LED D4 will glow, showing that the PIR is active.
Whenever motion is detected by the PIR, the predefined programmed glow pattern is
executed by the flash and auxiliary LEDs.
PIR sensor
7/10