AE-ISP-U1 Phyton Inc, AE-ISP-U1 Datasheet - Page 44

• Manufacturer Part Number: AE-ISP-U1
• Description: ADAPTER 28-DIP TO BH-10
• Manufacturer: Phyton Inc

Specifications of AE-ISP-U1

• Module/board Type: Adapter DIP28/BH-10
• For Use With/related Products: ChipProg+, ChipProg-40, ChipProg-48, ChipProg-G4, ChipProg-ISP
• For Use With: CHIPPROG-G4 - PROGRAMMER GANG 4 SOCKETCHIPPROG-40 - PROGRAMMER STANDALONE 40-DIPCHIPPROG-48 - PROGRAMMER STANDALONE 48-DIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AE-ISP-U1
* Must be connected if there is no external oscillator in system.
AE-ISP-U1 connection for the NXP/Philips P89xxx devices in the ICP Mode
Click the programmer model below to get an appropriate list of the devices supported by the
adapter:
Recommended connection:
http://www.phyton.com/downloads/adp/HTML/ae-isp-u1.html
Adapter Output connector, BH-10 Target Device P89LPC9xx
Isolating resistors:
Purpose of the R1..R3 resistors is to isolate the programmed chip from rest of target system.
Recommended value of resistors R1.. R3 is 2k or more. You can also use jumpers instead of the
resistors.
ChipProg+
ChipProg-40
ChipProg-48, ChipProg-G4
10
1
3
5
7
9
8
6
4
2
XTAL1*
GND
RXD
Powering the target device:
There are two alternative options for powering the
targets:
1. The target gets power from the programmer (Vdd).
This is possible only if the target does not consume too
much energy. A capacity of the target power circuitry
should not exceed 50 uF.
2. The target gets power from a built-in or external
power supply. In this case the power output from the
programmer should not be connected with the target.
The target system should be tolerant to applying
logical signals with the voltage levels exceeding the
voltages on the target.
NOTE! It is strictly prohibited to power the target from
both the programmer and built-in or external power
supply simultaneously.
VCC
TXD
RST
Page 44 of 56
8/19/2010