AE-ISP-U1 Phyton Inc, AE-ISP-U1 Datasheet - Page 28

• Manufacturer Part Number: AE-ISP-U1
• Description: ADAPTER 28-DIP TO BH-10
• Manufacturer: Phyton Inc

Specifications of AE-ISP-U1

• Module/board Type: Adapter DIP28/BH-10
• For Use With/related Products: ChipProg+, ChipProg-40, ChipProg-48, ChipProg-G4, ChipProg-ISP
• For Use With: CHIPPROG-G4 - PROGRAMMER GANG 4 SOCKETCHIPPROG-40 - PROGRAMMER STANDALONE 40-DIPCHIPPROG-48 - PROGRAMMER STANDALONE 48-DIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AE-ISP-U1
Table of connections of the adapter output socket to the device pins:
All power supply pins included AVdd must be powered. All ground pins included AVss must be
connected together.
AE-ISP-U1 connection for the Microchip PIC16/PIC18 devices
Click the programmer model below to get an appropriate list of the devices supported by the
adapter:
Recommended connection:
http://www.phyton.com/downloads/adp/HTML/ae-isp-u1.html
2. The cable length should be less then one foot.
Adapter Output connector, BH-10 Target Device PIC10/PIC12
1.3 logical pins - 5 mA.
ChipProg+
ChipProg-40
ChipProg-48, ChipProg-G4
10
1
3
5
7
9
8
6
4
2
MCLR/Vpp
Powering the target device:
There are two alternative options for powering the
targets:
1. The target gets power from the programmer (Vdd).
This is possible only if the target does not consume too
much energy. A capacity of the target power circuitry
should not exceed 50 uF.
2. The target gets power from a built-in or external
power supply. In this case the power output from the
programmer should not be connected with the target.
The target system should be tolerant to applying logical
signals with the voltage levels exceeding the voltages
on the target.
GND
GND
GP1
GP0
Vdd
-
-
-
-
Page 28 of 56
8/19/2010