AE-ISP-U1 Phyton Inc, AE-ISP-U1 Datasheet - Page 38

• Manufacturer Part Number: AE-ISP-U1
• Description: ADAPTER 28-DIP TO BH-10
• Manufacturer: Phyton Inc

Specifications of AE-ISP-U1

• Module/board Type: Adapter DIP28/BH-10
• For Use With/related Products: ChipProg+, ChipProg-40, ChipProg-48, ChipProg-G4, ChipProg-ISP
• For Use With: CHIPPROG-G4 - PROGRAMMER GANG 4 SOCKETCHIPPROG-40 - PROGRAMMER STANDALONE 40-DIPCHIPPROG-48 - PROGRAMMER STANDALONE 48-DIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AE-ISP-U1
Table of connections of the adapter output socket to the device pins:
All power supply pins included AVdd must be powered. All ground pins included AVss must be
connected together.
* -The signal needs to be connected, if it is required.
AE-ISP-U1 connection for the NEC UPD78F9210, UPD78F9211 devices
Click the programmer model below to get an appropriate list of the devices supported by the
adapter:
Recommended connection:
http://www.phyton.com/downloads/adp/HTML/ae-isp-u1.html
Adapter Output connector, BH-10 Target Device dsPIC33FJ
ChipProg+
ChipProg-40
ChipProg-48, ChipProg-G4
10
1
3
5
7
9
8
6
4
2
Vddcore*
MCLR
GND
GND
PGD
PGC
Vdd
Powering the target device:
There are two alternative options for powering the
targets:
1. The target gets power from the programmer
(Vdd). This is possible only if the target does not
consume too much energy. A capacity of the target
power circuitry should not exceed 50 uF.
2. The target gets power from a built-in or external
power supply. In this case the power output from
the programmer should not be connected with the
target. The target system should be tolerant to
applying logical signals with the voltage levels
exceeding the voltages on the target.
NOTE! It is strictly prohibited to power the target
from both the programmer and built-in or external
power supply simultaneously.
Page 38 of 56
8/19/2010