DC9S08QE8 Freescale Semiconductor, DC9S08QE8 Datasheet - Page 42

• Manufacturer Part Number: DC9S08QE8
• Description: DAUGHTER CARD FOR DEMO9S08QB8
• Manufacturer: Freescale Semiconductor

Specifications of DC9S08QE8

• Accessory Type: Daughter Card
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Core Sub-architecture: HCS08
• Silicon Core Number: MC9S08
• Silicon Family Name: Flexis - S08QE
• Kit Contents: Board
• Features: Four 8x2 Female Connectors
• Rohs Compliant: Yes
• For Use With/related Products: DEMO9S
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

38
DEMO9S08QB8 hardware. If this dialog indicates that the DEMO9S08QB8
hardware is not connected to the PC, the first step is to make sure that the
DEMO9S08QB8 hardware is connected to the PC via a USB 2.0 high-speed
cable. If it is connected, unplug and then plug in the USB cable on the
DEMO9S08QB8 board and click refresh in the connection assistant. If the
hardware still does not show up, try the following remedies:
(A) Re-Enable the USB driver
If you connected the DEMO9S08QB8 interface prior to installing P&E’s
Embedded Multilink drivers, Windows will not have been able to find the
appropriate driver and may have disabled the device. The DEMO9S08QB8
board shows up in Window’s device manager as a “P&E Multilink,” since it
contains P&E’s Embedded Multilink circuitry. If you unplug and then plug in
the device, Windows will automatically disable it even if you have installed the
drivers. To force windows to try to load the driver again, perform the following
steps while the DEMO9S08QB8 interface is connected to the computer:
(B) Re-Install the USB driver
If the Multilink device does not show up in the device manager, use the driver
installation utility located in the DEMOQE Resources DVD-ROM. After driver
installation, unplug the DEMO9S08QB8 from the PC and reboot the PC.
When the reboot has completed, connect the interface to the PC with the USB
2.0 cable. Run the software again to see if the interface is now detected.
If you have an error attempting to install the drivers, please view the
installation troubleshooting FAQ on P&E’s website at:
http://www.pemicro.com/faqs/faq_view.cfm?id=89.
(C) Test for installation of the USB driver files
To test the driver installation, use the driver test utility in the DEMOQE
1. Open the Control Panel (Start Button->Settings->Control Panel)
2. Double Click the "System" Icon
3. Select the "Hardware" tab
4. Click the "Device Manager" Button
5. The "P&E Multilink" device will be shown with an exclamation mark
6. Click the "Reinstall Driver…" button and follow the dialog instructions
next to it. Double-click this device.
to have Windows automatically install the driver.
DEMO9S08QB8 User Manual