DC9S08QE8 Freescale Semiconductor, DC9S08QE8 Datasheet - Page 14

• Manufacturer Part Number: DC9S08QE8
• Description: DAUGHTER CARD FOR DEMO9S08QB8
• Manufacturer: Freescale Semiconductor

Specifications of DC9S08QE8

• Accessory Type: Daughter Card
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Core Sub-architecture: HCS08
• Silicon Core Number: MC9S08
• Silicon Family Name: Flexis - S08QE
• Kit Contents: Board
• Features: Four 8x2 Female Connectors
• Rohs Compliant: Yes
• For Use With/related Products: DEMO9S
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3.5
3.5.1
10
Hardware Setup
First-Time Connection
Step 6.
The DEMO9S08QB8 may be connected to a PC through a USB port.
Connection steps are listed below in typical order:
1. Install the required software, as described in the previous section.
2. Make sure the jumpers for USB_PWR, 3V for VOLT_EN, and
3. Plug the USB cable A-M connector into a free USB port of the PC.
Figure 3-1: DEMOQE Logic Analyzer Application
REG_VDD for VDD_SELECT are installed.
http://www.pemicro.com/fixedlinks/demoQEtoolkit.html.
buzzer will vary as you rotate.
button at any time will turn off the buzzer sound and all the LEDs.
Optionally, you may run the DEMOQE Logic Analyzer Application
available in the DEMOQE toolkit on the CD. This PC-based
application graphs the IN0 and IN1 signals on the DEMOQE
board. If both J11 jumpers are installed, IN0 shows PTC0 and IN1
shows PTC1. Push button PTA2 three times after reset and turn
the potentiometer to change these signals. This application may
also be found at:
Pressing the PTA2 button a fourth time or pressing the PTA3
DEMO9S08QB8 User Manual