VN772K-E STMicroelectronics, VN772K-E Datasheet - Page 23

• Manufacturer Part Number: VN772K-E
• Description: IC SSR QUAD FOR H BRIDGE 28SOIC
• Manufacturer: STMicroelectronics
• Type: H Bridger

Specifications of VN772K-E

• Input Type: Non-Inverting
• Number Of Outputs: 4
• On-state Resistance: 60 mOhm
• Current - Output / Channel: 9A
• Voltage - Supply: 5.5 V ~ 36 V
• Operating Temperature: -40°C ~ 150°C
• Mounting Type: Surface Mount
• Package / Case: 28-SOIC (7.5mm Width)
• Device Type: Half Bridge
• Module Configuration: High And Low Side
• Peak Output Current: 9A
• Output Resistance: 0.12ohm
• Input Delay: 30µs
• Output Delay: 30µs
• Supply Voltage Range: 5.5V To 36V
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Peak Output: -

VN772K
3
Application recommendations
Figure 44. Application diagram bridge drivers
Most motor bridge drivers use a reverse battery protection diode (D) inside the supply rail.
This diode prevents a reverse current flow back to V
disabled via the logic inputs while motor inductance still carries energy. In order to prevent a
hazardous overvoltage at circuit supply terminal (V
limit the voltage overshoot. As basic orientation, 50µF per 1A load current is recommended.
As an alternative, a Zener protection (Z) is also suitable.
Even if a reverse polarity diode is not present, it is recommended to use a capacitor or
Zener at V
has intermittent electrical contact to the battery or gets disconnected while the motor is
operating.
CC
because a similar problem appears in case the supply terminal of the module
Doc ID 12535 Rev 3
CC
BATT
), a blocking capacitor (C) is needed to
in case the bridge becomes
Application recommendations
23/33