LDP10IG10-A Panduit Corp, LDP10IG10-A Datasheet - Page 139

• Manufacturer Part Number: LDP10IG10-A
• Description: RACEWAY 1CHAN LG AD LGY(10=10')
• Manufacturer: Panduit Corp
• Series: Pan-Way™r

Specifications of LDP10IG10-A

• Wire Duct Type: Solid (Raceway), Single Channel
• Height: 0.860" (21.80mm)
• Length: 10.00' (3.05m)
• Width: 1.51" (38.4mm)
• Mounting Type: Adhesive
• Features: Attached Latching Lid
• Color: Gray, Light

Surface non-metallic raceways are addressed under section 388 of the National Electric Code. Please reference
this section of the NEC for specific information regarding surface non-metallic raceway. 388 applies to a type of
surface non-metallic raceway and fittings of suitable non-metallic material that is resistant to moisture and
chemical atmospheres. It shall also be flame retardant, resistant to impact and crushing, resistant to distortion
from heat under conditions likely to be encountered in service, and resistant to low temperature effects.
Section 388 includes the following:
388.10 Uses Permitted
The use of surface non-metallic raceways shall be permitted in dry location. Surface non-metallic raceways shall
be permitted to pass transversely through dry walls, dry partitions, and dry floors if the length passing through is
unbroken. Access to the conductors shall be maintained on both sides of the wall, partition, or floor.
388.56 Splices and Taps
Splices and taps shall be permitted in surface non-metallic raceways having cover that is accessible after
installation. The conductors, including splices and taps, shall not fill the raceway to more than 75 percent of its
area at that point. Splices and taps in surface non-metallic raceways without removable covers shall be made
only in junction boxes. All splices and taps shall be made by approved methods.
388.70 Combination Raceways
Where combination surface non-metallic raceways are used both for signaling and for lighting and power
circuits, the different systems shall be run in separate compartments, identified by printed legend or by sharply
contrasting colors of the interior finish.
388.100 Construction
Surface non-metallic raceways shall be of such construction as will distinguish them from other raceways.
Surface non-metallic raceways and their elbows, couplings, and similar fittings shall be so designed that the
sections can be mechanically coupled together and installed without subjecting the wires to abrasion.
NEC Article 388 (2002) Brief Explanation
(Surface Non-Metallic Raceways)
For service and technical support, call 800-777-3300 (outside the U.S. and Canada, see back cover).
N11
Faceplates,
Furniture
LD Profile
Overview
Selection
Technical
Ultimate
Labeling
Twin-70
Boxes &
Glossary
System
System
Office
Outlet
Quick
Guide
TG-70
Index
Cove
T130
T-70
T-45
Pole
Info
ID
&
&