EPC1213LC20 Altera, EPC1213LC20 Datasheet - Page 86

• Manufacturer Part Number: EPC1213LC20
• Description: IC CONFIG DEVICE 212KBIT 20-PLCC
• Manufacturer: Altera
• Series: EPCr

Specifications of EPC1213LC20

• Programmable Type: OTP
• Memory Size: 212kb
• Voltage - Supply: 4.75 V ~ 5.25 V
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 20-PLCC
• For Use With: PLMJ1213 - PROGRAMMER ADAPTER 20 PIN J-LEAD
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 544-2188-5

3–34
Table 3–23. Serial Configuration Device Pin Description (Part 2 of 2)
Package
Configuration Handbook (Complete Two-Volume Set)
nCS
DCLK
V
GND
Name
CC
Pin
1
6
3, 7, 8
4
Pin Number
Package
f
in 8-Pin
SOIC
As shown in
16-pin device. In order to take advantage of vertical migration from EPSCS1 to
EPCS128, Altera recommends a layout for serial configuration devices.
Figure 3–23. Layout Recommendation for Vertical Migration from EPCS1 to EPCS128
EPCS1 and EPCS4 available in 8-pin small outline integrated circuit (SOIC) package.
EPCS16 available in 8-pin and 16-pin small outline integrated circuit (SOIC) packages.
EPCS64 and EPCS128 available in 16-pin small outline integrated circuit (SOIC)
package.
For more information about Altera device packaging including mechanical drawing
and specifications for this package, refer to the
Sheet.
7
16
1, 2, 9
10
Pin Number
in 16-Pin
Package
SOIC
Chapter 3: Serial Configuration Devices (EPCS1, EPCS4, EPCS16, EPCS64, and EPCS128) Data Sheet
Figure 3–21
Input
Input
Power
Ground
Pin Type
and
The active low chip select input signal toggles at the beginning and
end of a valid instruction. When this signal is high, the device is
deselected and the DATA pin is tri-stated. When this signal is low, it
enables the device and puts the device in an active mode. After power
up, the serial configuration device requires a falling edge on the nCS
signal before beginning any operation.
DCLK is provided by the FPGA. This signal provides the timing of the
serial interface. The data presented on ASDI is latched to the serial
configuration device on the rising edge of DCLK. Data on the DATA
pin changes after the falling edge of DCLK and is latched into the
FPGA on the next falling edge.
Power pins connect to 3.3 V.
Ground pin.
Figure
3–22, the serial configuration device is an 8-pin or
Pin 1 ID
Altera Device Package Information Data
Description
© December 2009
Altera Corporation
Package