M25P80-VMP6G NUMONYX, M25P80-VMP6G Datasheet - Page 21

• Manufacturer Part Number: M25P80-VMP6G
• Description: IC FLASH 8MBIT 75MHZ 8VFQFPN
• Manufacturer: NUMONYX
• Series: Forté™r

Specifications of M25P80-VMP6G

• Format - Memory: FLASH
• Memory Type: FLASH
• Memory Size: 8M (1M x 8)
• Speed: 75MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-VFQFN, 8-VFQFPN
• Clock Frequency: 50MHz
• Supply Voltage Range: 2.7V To 3.6V
• Memory Case Style: VFQFPN
• No. Of Pins: 8
• Base Number: 25
• Frequency: 75MHz
• Ic Generic: RoHS Compliant
• Memory Configuration: 1M X 8
• Interface Type: Serial, SPI
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

6.3
Note:
Table 5.
Manufacturer
identification
20h
Read Identification (RDID)
The Read Identification (RDID) instruction allows to read the device identification data:
The manufacturer identification is assigned by JEDEC, and has the value 20h for Numonyx.
The device identification is assigned by the device manufacturer, and indicates the memory
type in the first byte (20h), and the memory capacity of the device in the second byte (14h).
The UID contains the length of the following data in the first byte (set to 10h), and 16 bytes
of the optional Customized Factory Data (CFD) content. The CFD bytes are read-only and
can be programmed with customers data upon their request. If the customers do not make
requests, the devices are shipped with all the CFD bytes programmed to zero (00h).
See
devices.
Any Read Identification (RDID) instruction while an Erase or Program cycle is in progress, is
not decoded, and has no effect on the cycle that is in progress.
The device is first selected by driving Chip Select (S) Low. Then, the 8-bit instruction code
for the instruction is shifted in. After this, the 24-bit device identification, stored in the
memory, the 8-bit Unique ID code followed by 16 bytes of CFI content will be shifted out on
Serial Data Output (Q). Each bit is shifted out during the falling edge of Serial Clock (C).
The instruction sequence is shown in
The Read Identification (RDID) instruction is terminated by driving Chip Select (S) High at
any time during data output.
When Chip Select (S) is driven High, the device is put in the Standby Power mode. Once in
the Standby Power mode, the device waits to be selected, so that it can receive, decode and
execute instructions.
Read Identification (RDID) data-out sequence
Section 12: Ordering Information, Standard Parts on page 52
Manufacturer identification (one byte)
Device identification (two bytes)
A Unique ID code (UID) followed by 16 bytes of CFI data
Memory type
20h
Device identification
Memory capacity
Figure
14h
9.
UID
10h
for CFD programmed
CFI content
16 bytes
21/57