MT48LC64M8A2P-75:C Micron Technology Inc, MT48LC64M8A2P-75:C Datasheet - Page 39
![IC SDRAM 512MBIT 133MHZ 54TSOP](/photos/7/22/72261/557-54-tsop_sml.jpg)
MT48LC64M8A2P-75:C
Manufacturer Part Number
MT48LC64M8A2P-75:C
Description
IC SDRAM 512MBIT 133MHZ 54TSOP
Manufacturer
Micron Technology Inc
Type
SDRAMr
Datasheet
1.MT48LC64M8A2TG-75C_TR.pdf
(68 pages)
Specifications of MT48LC64M8A2P-75:C
Format - Memory
RAM
Memory Type
SDRAM
Memory Size
512M (64M x 8)
Speed
133MHz
Interface
Parallel
Voltage - Supply
3 V ~ 3.6 V
Operating Temperature
0°C ~ 70°C
Package / Case
54-TSOP II
Organization
64Mx8
Density
512Mb
Address Bus
15b
Access Time (max)
6/5.4ns
Maximum Clock Rate
133MHz
Operating Supply Voltage (typ)
3.3V
Package Type
TSOP-II
Operating Temp Range
0C to 70C
Operating Supply Voltage (max)
3.6V
Operating Supply Voltage (min)
3V
Supply Current
115mA
Pin Count
54
Mounting
Surface Mount
Operating Temperature Classification
Commercial
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
MT48LC64M8A2P-75:C
Manufacturer:
MITSUBISHI
Quantity:
450
PDF: 09005aef809bf8f3/Source: 09005aef80818a4a
512MbSDRAM.fm - Rev. L 10/07 EN
10. READs or WRITEs listed in the Command (Action) column include READs or WRITEs with
11. Does not affect the state of the bank and acts as a NOP to that bank.
5. The following states must not be interrupted by any executable command; COMMAND
6. All states and sequences not shown are illegal or reserved.
7. Not bank-specific; requires that all banks are idle.
8. May or may not be bank-specific; if all banks are to be precharged, all must be in a valid
9. Not bank-specific; BURST TERMINATE affects the most recent READ or WRITE burst, regard-
INHIBIT or NOP commands must be applied on each positive clock edge during these states.
state for precharging.
less of bank.
auto precharge enabled and READs or WRITEs with auto precharge disabled.
Accessing mode
Precharging all: Starts with registration of a PRECHARGE ALL command and ends when
Refreshing: Starts with registration of an AUTO REFRESH command and ends when
register:
t
state.
Starts with registration of a LOAD MODE REGISTER command and ends
when
all banks idle state.
t
RC is met. After
RP is met. After
t
MRD has been met. After
39
t
t
RC is met, the SDRAM will be in the all banks idle
RP is met, all banks will be in the idle state.
Micron Technology, Inc., reserves the right to change products or specifications without notice.
t
MRD is met, the SDRAM will be in the
512Mb: x4, x8, x16 SDRAM
©2000 Micron Technology, Inc. All rights reserved.
Operations