MT46H8M32LFB5-5 IT:H Micron Technology Inc, MT46H8M32LFB5-5 IT:H Datasheet - Page 39
![no-image](/images/manufacturer_photos/0/4/441/micron_technology_inc_sml.jpg)
MT46H8M32LFB5-5 IT:H
Manufacturer Part Number
MT46H8M32LFB5-5 IT:H
Description
IC DDR SDRAM 256MBIT 90VFBGA
Manufacturer
Micron Technology Inc
Type
DDR SDRAMr
Datasheet
1.MT46H16M16LFBF-5H.pdf
(96 pages)
Specifications of MT46H8M32LFB5-5 IT:H
Format - Memory
RAM
Memory Type
Mobile DDR SDRAM
Memory Size
256M (8Mx32)
Speed
200MHz
Interface
Parallel
Voltage - Supply
1.7 V ~ 1.95 V
Operating Temperature
-40°C ~ 85°C
Package / Case
90-VFBGA
Organization
8Mx32
Density
256Mb
Address Bus
14b
Access Time (max)
6.5/5ns
Maximum Clock Rate
200MHz
Operating Supply Voltage (typ)
1.8V
Package Type
VFBGA
Operating Temp Range
-40C to 85C
Operating Supply Voltage (max)
1.95V
Operating Supply Voltage (min)
1.7V
Supply Current
180mA
Pin Count
90
Mounting
Surface Mount
Operating Temperature Classification
Industrial
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
SELF REFRESH
DEEP POWER-DOWN
Figure 13: DEEP POWER-DOWN Command
PDF: 09005aef834bf85b
256mb_mobile_ddr_sdram_t36n.pdf - Rev. H 11/09 EN
The SELF REFRESH command is used to place the device in self refresh mode; self re-
fresh mode is used to retain data in the memory device while the rest of the system is
powered down. When in self refresh mode, the device retains data without external clock-
ing. The SELF REFRESH command is initiated like an AUTO REFRESH command,
except that CKE is disabled (LOW). After the SELF REFRESH command is registered, all
inputs to the device become “Don’t Care” with the exception of CKE, which must re-
main LOW.
Micron recommends that, prior to self refresh entry and immediately upon self refresh
exit, the user perform a burst auto refresh cycle for the number of refresh rows. Alterna-
tively, if a distributed refresh pattern is used, this pattern should be immediately
resumed upon self refresh exit.
The DEEP POWER-DOWN (DPD) command is used to enter DPD mode, which ach-
ieves maximum power reduction by eliminating the power to the memory array. Data
will not be retained when the device enters DPD mode. The DPD command is the same
as a BURST TERMINATE command with CKE LOW.
BA0, BA1
Address
RAS#
CAS#
WE#
CK#
CKE
CS#
CK
Don’t Care
39
256Mb: x16, x32 Mobile LPDDR SDRAM
Micron Technology, Inc. reserves the right to change products or specifications without notice.
©2008 Micron Technology, Inc. All rights reserved.
Commands