DM330023-2 Microchip Technology, DM330023-2 Datasheet - Page 70

• Manufacturer Part Number: DM330023-2
• Description: Power Management IC Development Tools dsPICDE MCHV-2
• Manufacturer: Microchip Technology
• Type: Motor / Motion Controllers & Driversr

Specifications of DM330023-2

• Rohs: yes
• Product: Development Boards
• Tool Is For Evaluation Of: PIC24F, PIC24E, dsPIC33F, dsPIC33E
• Input Voltage: 90 V to 265 V
• Output Voltage: 15 V
• Interface Type: UART
• Output Current: 0.75 A
• For Use With: PIC24F, PIC24E, dsPIC33F, dsPIC33E

B.5
B.6
B.7
DS52074A-page 70
DETERMINING DEVICE SUPPORT AND RESERVED RESOURCES
TROUBLESHOOTING
SETTINGS DIALOG AND INFO TAB
Due to the built-in in-circuit debugging capability of ICD devices and the ICSP function
offered by the debugger, the Starter Kit on Board uses some on-chip resources when
debugging. It also uses program memory and file register locations in the target device
during debugging. These locations are not available for use by user code. In the
MPLAB IDE, registers marked with an “R” in the register display represents reserved
registers.
For information on device resources that are needed for in-circuit debugging, please
refer to the MPLAB ICD 2 Help, found in MPLAB IDE under Help>Topics. The device
reserved resource information found under “Resources Used By MPLAB ICD 2” is the
same for the Starter Kit on Board.
B.6.1
While using the Starter Kit on Board as a debugger, you may receive the error “Starter
Kit on Board not connected to this computer” when programming the device. This can
result from communication being lost between the Starter Kit on Board and MPLAB
IDE. To resolve this:
1. Unplug the USB cable from the Starter Kit on Board.
2. Plug the USB cable back into the Starter Kit on Board.
MPLAB IDE should automatically reconnect to the Starter Kit on Board. If this does not
work, do the following:
1. Check the USB connection between the PC and Starter Kit on Board at both
2. If using a USB hub, make sure it is powered.
3. Make sure the USB port is not in use by another device.
B.6.2
If during the course of developing your own application you can no longer program the
device on the Starter Kit on Board, you may have set device configuration bits to code
protect or some other state that prevents programming. To view the settings of the
configuration bits, select Configure>Configuration bits.
When you select Debugger>Settings or Programmer Settings, you will open the Starter
Kit on Board Settings dialog. Currently, there is only one tab (Info) on this dialog, which
provides the following information:
• Firmware Version: The version of firmware on the Starter Kit on Board.
• Debug Exec Version: The version of the debug executive that is loaded into the
target device program memory to enable debug operation.
ends.
Debugging Connection Problems
PROGRAMMING PROBLEMS
 2012 Microchip Technology Inc.