DM330023-2 Microchip Technology, DM330023-2 Datasheet - Page 25

• Manufacturer Part Number: DM330023-2
• Description: Power Management IC Development Tools dsPICDE MCHV-2
• Manufacturer: Microchip Technology
• Type: Motor / Motion Controllers & Driversr

Specifications of DM330023-2

• Rohs: yes
• Product: Development Boards
• Tool Is For Evaluation Of: PIC24F, PIC24E, dsPIC33F, dsPIC33E
• Input Voltage: 90 V to 265 V
• Output Voltage: 15 V
• Interface Type: UART
• Output Current: 0.75 A
• For Use With: PIC24F, PIC24E, dsPIC33F, dsPIC33E

 2012 Microchip Technology Inc.
TABLE 2-1:
2.3.2
A mini-USB-to-USB certified cable and a standard DB9 male-to-female cable should
be used to connect the dsPICDEM™ MCHV-2 Development Board to the host
computer.
The communication port connectors are listed in
exact location.
TABLE 2-2:
2.3.3
The recommended connection sequence is listed below. The user should ensure that
the following sequence is met before connecting the system to the mains, a motor and
a host computer.
1. Connect the motor terminals R, Y, and B (also known as RWB or 123 or ABC) to
2. Follow the next steps if position sensors are utilized to control the motor. If not,
Number
Note:
12
13
14
15
16
the connection nodes M1, M2, and M3 (4, 5, and 6 in
proceed to step 3.
a) If the motor position is sensed with Hall Sensors, connect the terminals A, B,
b) If the motor position is sensed with a Quadrature Encoder, connect the ter-
Number
and C to the connection nodes HA, HB, and HC (7, 8, and 9 in
respectively. Also, connect the positive terminal +5V to the connection node
+5V and the ground terminal to the connection node GND (10 and 11 in
Figure
minals phase A, phase B, and Index to the connection nodes HA, HB, and
HC (7, 8, and 9 in
10
11
USB-to-UART connector
RS-232- to-UART connector
USB connector for the Starter Kit on Board programmer/debugger
Non-isolated ICSP™ connector for device programming/debugging
Matrix board
Host/Communication Connections
Connection Sequence
Before making any connection, verify that the system is not powered and it
is fully discharged. The system is completed discharged when the red LED
D13 is OFF.
1
2
3
4
5
6
7
8
9
2-5).
POWER CONNECTIONS
I/O CONNECTORS
Neutral
Earth Ground
Live (Fused)
Motor Phase 1 (M1)
Motor Phase 2 (M2)
Motor Phase 3 (M3)
Hall Sensor A (HA)
Hall Sensor B (HB)
Hall Sensor C (HC)
Hall Sensors, 5V power supply terminal
Hall Sensors, Ground terminal
Figure
2-5), respectively.
Name
Name
Table
2-2. Refer to
Figure
2-5), respectively.
Figure 2-5
DS52074A-page 25
Figure
Output
Output
Output
Output
Output
Type
Input
Input
Input
Input
Input
Input
Input/Output
Input/Output
Input/Output
Input/Output
Input/Output
Type
for their
2-5),