STGIPS30C60 STMicroelectronics, STGIPS30C60 Datasheet - Page 15

• Manufacturer Part Number: STGIPS30C60
• Description: IGBT Transistors SLLIMM IPM 3-Phase 30A 600V IGBT
• Manufacturer: STMicroelectronics

Specifications of STGIPS30C60

• Rohs: yes
• Configuration: Single
• Collector- Emitter Voltage Vceo Max: 600 V
• Collector-emitter Saturation Voltage: 1.9 V
• Continuous Collector Current At 25 C: 30 A
• Power Dissipation: 52 W
• Maximum Operating Temperature: + 150 C
• Package / Case: SDIP-25
• Minimum Operating Temperature: - 40 C
• Mounting Style: Through Hole
• Tradename: SLLIMM

STGIPS30C60
5.1
Note:
Recommendations








For further details refer to AN3338.
Symbol
f
t
V
V
V
PWM
dead
T
CC
PN
BS
C
Input signal HIN is active high logic. A 85 k (typ.) pull down resistor is built-in for each
high side input. If an external RC filter is used, for noise immunity, pay attention to the
variation of the input signal level.
Input signal LIN is active low logic. A 720 k (typ.) pull-up resistor, connected to an
internal 5 V regulator through a diode, is built-in for each low side input.
To prevent the input signals oscillation, the wiring of each input should be as short as
possible.
By integrating an application specific type HVIC inside the module, direct coupling to
MCU terminals without any opto-coupler is possible.
Each capacitor should be located as nearby the pins of IPM as possible.
Low inductance shunt resistors should be used for phase leg current sensing.
Electrolytic bus capacitors should be mounted as close to the module bus terminals as
possible. Additional high frequency ceramic capacitor mounted close to the module
pins will further improve performance.
The SD/OD signal should be pulled up to 5 V / 3.3 V with an external resistor (see
Section 4: Smart shutdown function
Control supply voltage Applied between V
High side bias voltage
prevent Arm-short
PWM input signal
Blanking time to
Case operation
Supply Voltage
temperature
Parameter
Table 13. Recommended operating conditions
DocID022471 Rev 3
Applied between P-Nu,Nv,Nw
Applied between V
i=U,V,W
For each input signal
-40°C < T
-40°C < T
for detailed info).
c
j
< 125°C
< 100°C
Conditions
CC
BOOTi
-GND
-OUT
i
for
Applications information
Min.
13.5
13
1
Value
Typ.
300
15
Max.
400
100
18
18
20
Unit
15/21
kHz
µs
°C
V
V
V