MCIMX6L3DVN10AA Freescale Semiconductor, MCIMX6L3DVN10AA Datasheet - Page 26

• Manufacturer Part Number: MCIMX6L3DVN10AA
• Description: Processors - Application Specialized i.MX6 Megrez
• Manufacturer: Freescale Semiconductor
• Type: Multimedia Applicationsr

Specifications of MCIMX6L3DVN10AA

• Rohs: yes
• Core: ARM Cortex A9
• Processor Series: i.MX6
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 1 GHz
• Data Ram Size: 128 KB
• Maximum Operating Temperature: + 95 C
• Mounting Style: SMD/SMT
• Package / Case: MAPBGA-432
• Interface Type: I2C, I2S, UART, USB
• Memory Type: L1/L2 Cache, ROM, SRAM
• Minimum Operating Temperature: 0 C
• Number Of Timers: 2

Electrical Characteristics
4.1.7
4.1.7.1
In power down mode, everything is powered down, including the VBUS valid detectors, typ condition.
Table 13
4.2
The system design must comply with power-up sequence, power-down sequence, and steady state
guidelines as described in this section to guarantee the reliable operation of the device. Any deviation
from these sequences may result in the following situations:
4.2.1
For power-up sequence, the restrictions are as follows:
26
Current
•
•
•
•
•
•
Excessive current during power-up phase
Prevention of the device from booting
Irreversible damage to the processor (worst-case scenario)
VDD_SNVS_IN supply must be turned ON before any other power supply. It may be connected
(shorted) with VDD_HIGH_IN supply.
If a coin cell is used to power VDD_SNVS_IN, then ensure that it is connected before any other
supply is switched on.
If VDD_ARM_IN and VDD_SOC_IN are connected to different external supply sources, then
VDD_ARM_IN supply must be turned ON together with VDD_SOC_IN supply or not delayed
more than 1 ms.
shows the USB interface current consumption in power down mode.
Power Supplies Requirements and Restrictions
USB PHY Current Consumption
Power-Up Sequence
Power Down Mode
The currents on the VDDHIGH_CAP and VDDUSB_CAP were identified
to be the voltage divider circuits in the USB-specific level shifters.
The POR_B input (if used) must be immediately asserted at power-up and
remain asserted until the last power rail reaches its working voltage. In the
absence of an external reset feeding the POR_B input, the internal POR
module takes control. See the i.MX 6SoloLite reference manual for further
details and to ensure that all necessary requirements are being met.
i.MX 6SoloLite Applications Processors for Consumer Products, Rev. 1
Table 13. USB PHY Current Consumption in Power Down Mode
VDDUSB_CAP (3.0 V)
5.1 μA
NOTE
NOTE
VDDHIGH_CAP (2.5 V)
1.7 μA
NVCC_PLL_OUT (1.1 V)
Freescale Semiconductor
<0.5 μA