MAX3107EVKIT+ Maxim Integrated, MAX3107EVKIT+ Datasheet - Page 48

• Manufacturer Part Number: MAX3107EVKIT+
• Description: UART Interface IC UART with integrated Oscillator
• Manufacturer: Maxim Integrated

Specifications of MAX3107EVKIT+

• Number Of Channels: 1
• Data Rate: 24 Mbps
• Supply Voltage - Max: 3.6 V
• Supply Voltage - Min: 1.71 V
• Supply Current: 4 mA

MAX3107
48
Figure 23. Startup and Initialization Flowchart
SPI/I
To reduce the power consumption during normal opera-
tion, the following techniques can be adopted:
• Do not use the internal PLL. This saves the most power
• Keep the internal clock rates as low as possible.
• Use low voltage on the V
• Use an external 1.8V supply. This saves the power
of the options listed here. Disable and bypass the PLL.
With the PLL enabled, the current to the V
in the range of a few mA (depending on clock and
multiplication factor), while it drops to below 1mA if
disabled.
dissipated in the internal 1.8V linear regulator for the
1.8V logic supply. Connect the external 1.8V supply to
V
LDOEN to DGND.
18
and disable the internal regulator by connecting
2
C UART with 128-Word FIFOs
RST INPUT PULLED HIGH/
RST BIT SET LOW
SUCCESSFULLY
IS IRQ HIGH?
POWER-UP/
CONFIGURE
CONFIGURE
RevID READ
CLOCKING
MODES
OR
A
Low-Power Operation
Y
supply.
N
A
supply is
The host controller can manage and control the MAX3107
through polling and/or through interrupts. In polled
mode, the IRQ physical interrupt output is not used and
the host controller polls the ISR register at frequent inter-
vals to establish the state of the MAX3107.
Alternatively, the MAX3107’s physical IRQ interrupt
can be used to interrupt the host controller at specified
events, making polling unnecessary. The IRQ output is
an open-drain output that requires a pullup resistor to V
The MAX3107 can be directly connected to transceivers
and controllers that have different supply voltages. The
V
ler interface while the V
the transceiver interface. This ensures flexibility when
selecting a controller and transceiver. Figure 24 is an
example of a setup when the controller, transceiver, and
the MAX3107 are powered by three different supplies.
L
input defines the logic voltage levels of the control-
COMMUNICATION
FLOW CONTROL
FIFO CONTROL
INTERRUPTS
CONFIGURE
CONFIGURE
CONFIGURE
ENABLE
START
GPIOs
EXT
Logic-Level Translation
voltage defines the logic of
Interrupts and Polling
Maxim Integrated
L
.