GS-BT2416C1AT1 STMICROELECTRONICS [STMicroelectronics], GS-BT2416C1AT1 Datasheet - Page 29

• Manufacturer Part Number: GS-BT2416C1AT1
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

GS-BT2416C1.AT1
A.24
Note:
A.25
See AT+BTCONNECT
AT+BTDISCONNECT
Disconnect the current existing SPP Bluetooth
command returns an OK message and GPIO1 is set to low.
AT+ECHO
Enable or disable the output of events and functional messages by the module.
Syntax:
Parameters:
BdAddress: Bluetooth
6-byte hexadecimal value: i.e.
PortN: Port number of the remote SPP port. A value of “0” force the device to
query the remote device for a SPP service port and to get the first valid port; this
behavior is useful for programmed automatic recursive connect.
PinCode: 4 to 16-byte string representing the connection pin code
NRetry: number of possible attempts if the connection fail. A “0” set the device for
infinite attempts. Value range is 0 - 255.
TimeRetry: time interval between attempts in seconds. Value range is 0 - 65535
Return value: <OK, ERROR>
Syntax: AT+BTDISCONNECT
Return value: <OK, ERROR>
Syntax: AT+ECHO=<ON,OFF>
Parameters:
ON: The ECHO mode is enabled and every message or events by the module will
be outputted. (default)
OFF: The ECHO mode is disabled and no output will be generated.
Return value: <OK, ERROR>
AT+BTCONNECT=00230A01F0A5
AT+BTCONNECT=BdAddress,PortN,
®
address of the remote device. This value is specified as a
®
link. When the link has been closed, the
“PinCode”,NRetry, TimeRetry
AT command
29/38