EVAL-CONTROLBOARD AD [Analog Devices], EVAL-CONTROLBOARD Datasheet - Page 15

• Manufacturer Part Number: EVAL-CONTROLBOARD
• Description: 16-Bit, 100 kSPS CMOS ADC
• Manufacturer: AD [Analog Devices]

PARALLEL INTERFACE
The AD7660 is configured to use the parallel interface when the
SER/PAR is held low. The data can be read either after each
conversion, which is during the next acquisition phase, or during
the following conversion as shown, respectively, in Figure 14 and
Figure 15. When the data is read during the conversion, how-
ever, it is recommended, that it is read only during the first half
of the conversion phase. That avoids any potential feedthrough
between voltage transients on the digital interface and the most
critical analog conversion circuitry.
SERIAL INTERFACE
The AD7660 is configured to use the serial interface when the
SER/PAR is held high. The AD7660 outputs 16 bits of data,
MSB first, on the SDOUT pin. This data is synchronized with
the 16 clock pulses provided on the SCLK pin.
DATA BUS
CNVST, RD
DATA BUS
DATA BUS
BUSY
CS = 0
BUSY
CNVST
CS = RD = 0
RD
CS
BUSY
t
12
t
t
t
12
3
3
PREVIOUS CONVERSION DATA
CONVERSION
CONVERSION
PREVIOUS
CURRENT
t
t
1
1
MASTER SERIAL INTERFACE
Internal Clock
The AD7660 is configured to generate and provide the serial
data clock SCLK when the EXT/INT pin is held low. The AD7660
also generates a SYNC signal to indicate to the host when the
serial data is valid. The serial clock SCLK and the SYNC signal
can be inverted if desired. The output data is valid on both the
rising and falling edge of the data clock. Depending on RDC/
SDIN input, the data can be read after each conversion, or
during the following conversion. Figure 16 and Figure 17 show
the detailed timing diagrams of these two modes.
Usually, because the AD7660 has a longer acquisition phase
than the conversion phase, the data is read immediately after
conversion. That makes the mode master, read after conver-
sion, the most recommended serial mode when it can be used.
In read-after-conversion mode, it should be noted that, unlike
in other modes, the signal BUSY returns low after the 16 data
bits are pulsed out and not at the end of the conversion phase
t
t
13
13
t
t
10
t
4
4
t
11
NEW DATA
AD7660