SH3000UM SEMTECH [Semtech Corporation], SH3000UM Datasheet - Page 12

• Manufacturer Part Number: SH3000UM
• Manufacturer: SEMTECH [Semtech Corporation]

Watchdog Timer
The second circuit for supervising the processor is the
watchdog timer. Whereas the low V
monitors supply voltage, the watchdog timer monitors be-
havior. It is based on a programmable timer that must be
restarted periodically by the host micro. If software fails
to restart the timer, the watchdog resets the processor.
Restarting the timer takes considerable processing, mak-
ing it unlikely that it would occur accidentally, as might
happen for a simple pin-strobe confi guration of typical
watchdog IC.
The watchdog is disabled after reset occurs. It stays dis-
abled until initialized by the host processor. The initializa-
tion requires the watchdog clock mode to be selected (see
Figure 1) and the 7-bit time-out value to be set. As soon
as the time-out is written, the watchdog begins operations
and can not be stopped; also, the time-out value and or
clock source can no longer be changed.
The two clock sources available for the watchdog are the
internal 32.768kHz clock and the CLK
operating from the 32.768kHz source, the time-out inter-
val is programmable from 7.8125ms to one second with
resolution of 7.8125ms. The internal 32.768kHz clock is
running all the time, therefore the time-out duration is
fi xed and predictable.
When operating from the CLK
programmable between 256 and 32768 cycles of CLK
with resolution of 256 cycles. The actual time-out duration
©2006 Semtech Corp.
POWER MANAGEMENT
Application Information
OUT
(continued)
signal the time-interval is
DD
/Brownout Detector
OUT
signal. When
OUT
Not authorized for release outside of Semtech
12
is variable and depends both on the frequency of CLK
signal and the amount of time target micro spends in the
STOP mode, when the CLK
These two clock modes, together with the programmable
time-out value, allow the SH3003 exceptional fl exibility,
previously unattainable by existing discrete watchdog so-
lutions.
The watchdog timer is kept from timing out by periodic
reload of the time-out value, triggered by a write of a code
byte to the Watchdog Reload Register. As a further safety
measure, there are two different and alternating code
bytes that should be written to the same Watchdog Re-
load Register. The code values are 0x5A and 0xC3. The
timer is reloaded after every write of a single code byte.
The code byte should be written to the Watchdog Reload
Register, or reset is activated when the watchdog timer
expires. Also, reset is initiated immediately if the value of
the code byte is incorrect or out of sequence. When the
watchdog triggers the reset, its duration is 12ms.
Using two separate software routines, each to write one of
the code values, results in the highest level of system se-
curity. These routines must execute in the correct order. It
is unlikely that runaway code could manage this. In addi-
tion, this design makes it diffi cult for the code to become
stuck in a tight loop resetting the watchdog.
OUT
signal is also stopped.
www.semtech.com
SH3003
- DRAFT
OUT