D38999/49 Defense Supply Center, D38999/49 Datasheet - Page 32

• Manufacturer Part Number: D38999/49
• Description: D38999K / D38999J 500 Cycle Contact
• Manufacturer: Defense Supply Center

the qualifying activity the capability of manufacturing products which meet the performance requirements of
this specification. Refer to the qualifying activity for the guidelines necessary to retain qualification to this
particular specification. The contractor shall immediately notify the qualifying activity at any time that the
inspection data indicates failure of the qualified product to meet the performance requirements of this
specification.
B inspections. The documentation requirements of the applicable military or industry test procedures do not
apply.
examined for completeness, workmanship, and identification requirements. Attention shall be given to
those assemblies that require a gasket to determine the condition of the gasket. Gaskets missing, twisted,
buckled, kinked, or damaged in any way shall be cause for rejection. Each connector (except hermetics)
shall be visually inspected for the presence of filler compound in the cavity between wire termination end of
insert and shell.
the pertinent military standard are considered critical.
4.3.3.1 Failures. One or more failures shall be cause for refusal to grant qualification.
4.3.4 Retention of qualification. To retain qualification, the contractor shall verify in coordination with
4.4 Conformance inspection.
4.4.1 Inspection of product for delivery. Inspection of product for delivery shall consist of groups A and
4.4.1.1 Group A inspection. Group A inspection shall consist of the inspections specified in table XIII.
4.4.1.1.1 Visual examination (group A inspection). Each connector and accessory shall be visually
4.4.1.1.2 Critical examinations (group A inspection). The following dimensions and features shown on
a. Mating diameters H and W for series I, II, and III; LL, L and MM for series IV of figures 1, 2, 3, and
b. Key or keyway positions.
c. Contact pattern relative to datum features (hermetics only).
d. Registration of grommet and insert markings. (Hole pattern between the grommet and the front
1/ Contacts shipped with connectors other than hermetics shall be from lots that have met
2/ 100-percent inspection.
3/ The contractor may use in-process controls for this requirement.
4/ Test between two adjacent contacts and between two peripheral contacts and the shell.
Inspection
Visual inspection 2/ --------------------------------------------------
Critical examination 2/ 3/ -------------------------------------------
Insulation resistance at ambient temperature 2/ 3/ 4/ ----
Dielectric withstanding voltage at sea level 2/ 3/ 4/ --------
Air leakage (hermetics only) 2/ 3/ -------------------------------
7 (maximum on plugs, minimum on receptacles).
face of the insert.)
the requirements of MIL-C-39029.
TABLE XIII. Group A inspection. 1/
MIL-DTL-38999K
32
3.1, 3.3, 3.4, 3.5,
3.43, and 3.4
Requirement
paragraph
3.13.1
3.14
3.1
3.9
paragraph
4.4.1.1.1
4.4.1.1.2
4.5.10.1
4.5.9.1
4.5.5
Test