ADG725 Analog Devices, ADG725 Datasheet - Page 12

• Manufacturer Part Number: ADG725
• Description: 16-/32- Channel/ Serially Controlled 4 1.8 V to 5.5 V/ 2.5 V/ Analog Multiplexers
• Manufacturer: Analog Devices

PRELIMINARY TECHNICAL DATA
ADG725/ADG731
GENERAL DESCRIPTION
The ADG725 and ADG731 are serially controlled, 32
channel and dual/differential 16 channel multiplexers re-
spectively.
POWER ON RESET
On power up of the device, all switches will be in the
OFF condition and the internal shift register is filled with
zeros and will remain so until a valid write takes place.
SERIAL INTERFACE
The ADG725 and ADG731 have a three wire serial inter-
face (
, SCLK, and DIN), which is compatible with
SPI, QSPI, MICROWIRE interface standards and most
DSP’s. Figure 1 shows the timing diagram of a typical
write sequence.
Data is written to the 8-bit shift register via DIN under
the control of the
and SCLK signals.
When
goes low, the input shift register is enabled.
An 8-bit counter is also enabled. Data from DIN is
clocked into the shift register on the falling edge of
SCLK. Figures 2 & 3 show the contents of the input shift
registers for these devices. When the part has received
eight clock cycles after
has been pulled low, the
switches are automatically updated with the new
configuration and the input shift register is disabled. With
held high, any further data or noise on the DIN
line will have no effect on the shift register.
The ADG725
and
data bits allow the user the
flexibility to change the configuration of either or both
banks of the multiplexer.
–12–
REV. PrD