M24LR64-RDW6T2 STMICROELECTRONICS [STMicroelectronics], M24LR64-RDW6T2 Datasheet - Page 15

• Manufacturer Part Number: M24LR64-RDW6T2
• Description: 64 Kbit EEPROM with password protection & dual interface
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

M24LR64-R
2.6
Note:
2.6.1
2.6.2
2.6.3
2.6.4
Supply voltage (V
This pin can be connected to an external DC supply voltage.
An internal voltage regulator allows the external voltage applied on V
M24LR64-R, while preventing the internal power supply (rectified RF waveforms) to output a
DC voltage on the V
Operating supply voltage V
Prior to selecting the memory and issuing instructions to it, a valid and stable V
within the specified [V
maintain a stable DC supply voltage, it is recommended to decouple the V
suitable capacitor (usually of the order of 10 nF) close to the V
This voltage must remain stable and valid until the end of the transmission of the instruction
and, for a Write instruction, until the completion of the internal I²C write cycle (t
Power-up conditions
When the power supply is turned on, V
vary faster than 1V/µs.
Device reset
In order to prevent inadvertent write operations during power-up, a power-on reset (POR)
circuit is included. At power-up (continuous rise of V
instruction until V
lower than the minimum V
over the POR threshold, the device is reset and enters the Standby Power mode, however,
the device must not be accessed until V
within the specified [V
In a similar way, during power-down (continuous decrease in V
below the power-on reset threshold voltage, the device stops responding to any instruction
sent to it.
Power-down conditions
During power-down (continuous decay of V
(mode reached after decoding a Stop condition, assuming that there is no internal write
cycle in progress).
CC
CC
has reached the power-on reset threshold voltage (this threshold is
CC
CC
pin.
(min), V
(min), V
CC
CC
operating voltage defined in
Doc ID 15170 Rev 10
)
CC
CC
CC
(max)] range must be applied (see
(max)] range.
CC
CC
rises from V
has reached a valid and stable V
CC
), the device must be in Standby Power mode
CC
SS
), the device does not respond to any
to V
Table
CC
CC
CC
. The V
100). When V
/V
), as soon as V
SS
CC
Table
package pins.
CC
Signal description
to supply the
rise time must not
CC
CC
100). To
line with a
CC
W
CC
voltage
).
CC
passes
voltage
drops
15/128