NCP1280_05 ONSEMI [ON Semiconductor], NCP1280_05 Datasheet - Page 3

• Manufacturer Part Number: NCP1280_05
• Description: Active Clamp Voltage Mode PWM Controller for Off-Line Applications
• Manufacturer: ONSEMI [ON Semiconductor]

PIN DESCRIPTION
Pin
10
11
12
13
14
15
16
1
2
3
4
5
6
7
8
9
UV/OV
DC
CSKIP
Name
OUT2
OUT1
V
GND
V
V
NC
CS
SS
V
FF
R
AUX
REF
t
EA
MAX
D
in
T
This pin is connected to the input voltage of the system. The voltage can be a rectified, filtered line voltage
or output of a power factor correction (PFC) front end. A constant current source supplies current from this
pin to the capacitor connected on the V
voltage is 700 V.
Not Connected.
Provides protection under line undervoltage and overvoltage conditions. The built in voltage range is
X 2:1. If needed, the OV function can be disabled by a Zener from this pin to ground.
An external resistor between V
to V
regulation is improved.
Overcurrent sense input. If the CS voltage exceeds 0.48 V or 0.57 V, the converter enters the Cycle by
Cycle or Cycle Skip current limit mode, respectively.
The capacitor connected between this pin and ground sets the Cycle Skip period. A soft−start sequence
follows at the conclusion of the fault period.
A single external resistor between this pin and GND sets the oscillator fixed frequency.
An external resistor between this pin and GND sets the voltage on the Max DC Comparator inverting
input. The duty cycle is limited by comparing the voltage on the Max DC Comparator inverting input to the
Feedforward Ramp.
An internal 6.2 mA current source charges the external capacitor connected to this pin. The duty cycle is
limited during startup by comparing the voltage on this pin to the Oscillator Ramp.
The error signal from an external error amplifier, typically supplied through an optocoupler, is fed into this
input and compared to the Feedforward Ramp. A series diode and resistor offset the voltage on this pin
before it is applied to the PWM Comparator inverting input.
Precision 5.0 V reference output. Maximum output current is 6 mA.
An external resistor between V
transitions.
Output of the PWM controller with leading and trailing edge overlap delay. OUT2 can be used to drive a
synchronous rectifier topology, an active clamp/reset switch, or both.
Control circuit ground.
Main output of the PWM controller.
Positive input supply voltage. This pin is connected to an external capacitor for energy storage. An
internal current supplies current from V
source turns OFF. It turns ON again once V
the IC via this pin, by means of an auxiliary winding.
in
. By varying the feedforward ramp amplitude in proportion to the input voltage, open loop line
http://onsemi.com
in
REF
NCP1280
and this pin adjusts the amplitude of the Feedforward Ramp in proportion
and this pin sets the overlap delay between OUT1 and OUT2
3
in
AUX
Application Information
to this pin. Once the voltage on V
pin. The charge current is typically 13.8 mA. Maximum input
AUX
falls to 7 V. During normal operation, power is supplied to
AUX
reaches 11 V, the current