PSD813F1A-12J STMICROELECTRONICS [STMicroelectronics], PSD813F1A-12J Datasheet - Page 12

• Manufacturer Part Number: PSD813F1A-12J
• Description: Flash In-System Programmable (ISP) Peripherals for 8-bit MCUs, 5V
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

PSD813F1
Note: 1. The pin numbers in this table are for the PLCC package only. See the
12/110
Pin Name
GND
PC5
PC6
PC7
PD0
PD1
PD2
V
2. These functions can be multiplexed with other functions.
CC
13
12
11
10
9
8
15, 38
1, 16,
26
Pin
Type
I/O
I/O
I/O
I/O
I/O
I/O
PC5 pin of Port C. This port pin can be configured to have the following functions:
1. MCU I/O – write to or read from a standard output or input port.
2. CPLD macrocell (McellBC5) output.
3. Input to the PLDs.
4. TDI input
This pin can be configured as a CMOS or Open Drain output.
PC6 pin of Port C. This port pin can be configured to have the following functions:
1. MCU I/O – write to or read from a standard output or input port.
2. CPLD macrocell (McellBC6) output.
3. Input to the PLDs.
4. TDO output
This pin can be configured as a CMOS or Open Drain output.
PC7 pin of Port C. This port pin can be configured to have the following functions:
1. MCU I/O – write to or read from a standard output or input port.
2. CPLD macrocell (McellBC7) output.
3. Input to the PLDs.
4. DBE – active Low Data Byte Enable input from 68HC912 type MCUs.
This pin can be configured as a CMOS or Open Drain output.
PD0 pin of Port D. This port pin can be configured to have the following functions:
1. ALE/AS input latches address output from the MCU.
2. MCU I/O – write or read from a standard output or input port.
3. Input to the PLDs.
4. CPLD output (External Chip Select).
PD1 pin of Port D. This port pin can be configured to have the following functions:
1. MCU I/O – write to or read from a standard output or input port.
2. Input to the PLDs.
3. CPLD output (External Chip Select).
4. CLKIN – clock input to the CPLD macrocells, the APD Unit’s Power-down counter, and
the CPLD AND Array.
PD2 pin of Port D. This port pin can be configured to have the following functions:
1. MCU I/O – write to or read from a standard output or input port.
2. Input to the PLDs.
3. CPLD output (External Chip Select).
4. PSD Chip Select Input (CSI). When Low, the MCU can access the PSD memory and I/
O. When High, the PSD memory blocks are disabled to conserve power.
Supply Voltage
Ground pins
2
for the JTAG Interface.
2
for the JTAG Interface.
Description
Figure 2., page
(1)
7, for pin numbers on other package type.