HS1-246RH-Q INTERSIL [Intersil Corporation], HS1-246RH-Q Datasheet - Page 4

• Manufacturer Part Number: HS1-246RH-Q
• Description: Radiation Hardened Triple Line(party-Line) Transmitter
• Manufacturer: INTERSIL [Intersil Corporation]

Transmitter
The HS-245RH transmitters have two inputs per transmitter,
either of which is low while the other is open during normal
operation and both inputs are open during standby. For
optimum transmitter performance, the “off” input should be
open circuit rather than being pulled towards +5V, because
this will reduce the “on” output data current. On the other
hand, the “on” and “off” output data current will increase if
the “off” input is held below its open circuit voltage. Open
collector gates such as the 7401 and 7403 or 7405 Hex-
Inverter are suitable for driving the HS-245RH transmitter
inputs. By using 2-input gates as shown in Figure 6, an
enable line can be provided so that more than one
transmitter may be connected to a line for time sharing.
When the enable line is low the transmitter will be disabled
and will present a high impedance to the transmission line
as well as requiring very little power supply current.
Complementary input signals may be derived from high
speed inverter gates as shown, or by using the
complementary outputs of a flip-flop. When the transmitter is
connected near the midpoint of a long transmission line or to
a line with terminations at both ends, two transmitter
sections should be paralleled with respective inputs and
outputs connected together in order to drive the reduced
impedance. This parallel transmitter technique can also be
used to increase the data rate on long transmission lines.
Operating Temperature Range
Power Supply
Propagation Delay
Input Impedance and
Output Circuit
ICC (VCC = +5.0V)
PARAMETER
Operating Temperature Range
“ON” Output Current
Power Supply Current
Standby Current
Propagation Delay
PARAMETER
4
TABLE A. GENERAL TRANSMITTER/RECEIVER CHARACTERISTICS
HS-246RH/248RH
HS-246RH/248RH
RECEIVER TYPE
HS-245RH, HS-246RH, HS-248RH
All Receivers
HS-246RH
HS-248RH
TRIPLE LINE TRANSMITTER
TRIPLE LINE RECEIVER
HS-245RH
-55 to 125
7.0 Max
1.0 Min
33 Max
14 Max
-55 to 125
LIMITS
INPUT
Hi-Z
100
2.6
30
1/3
HS-245RH
FIGURE 4. TYPICAL DATA TRANSMISSION SYSTEM
UNITS
mA
mA
o
+5
ns
C
A
GND
IN
Over Full Temperature Range
Per Transmitter Section
Per Transmitter Section
Over Full Temperature Range
UNITS
G1
mA
o
ns
C
ENABLE
COMMENTS
GND
1/3
HS-248RH
G2
G3
Per Receiver Section
Over Full Temperature Range
Open Collector
6K Pull-Up Resistor
+5V
REQUIRED FOR HS-246RH
-5V
COMMENTS
2K-6K FOR TTL DRIVE
GND
OUTPUT
1/3
HS-246RH
+5V
-5V
OUT
OUT