DP83848YB_08 NSC [National Semiconductor], DP83848YB_08 Datasheet - Page 12

no-image

DP83848YB_08

Manufacturer Part Number
DP83848YB_08
Description
Manufacturer
NSC [National Semiconductor]
Datasheet
www.national.com
1.5 JTAG Interface
1.6 Reset and Power Down
1.7 Strap Options
The DP83848YB uses many of the functional pins as strap options. The values of these pins are sampled during reset
and used to strap the device into specific modes of operation. The strap option pin assignments are defined below. The
functional pin name is indicated in parentheses.
A 2.2 k
required, then there is no need for external pull-up or pull down resistors. Since these pins may have alternate functions
after reset is deasserted, they should not be connected directly to V
TCK
TDI
TDO
TMS
TRST#
RESET_N
PWR_DOWN/INT
PHYAD0 (COL)
PHYAD1 (RXD_0)
PHYAD2 (RXD_1)
PHYAD3 (RXD_2)
PHYAD4 (RXD_3)
Signal Name
Signal Name
Signal Name
resistor should be used for pull-down or pull-up to change the default strap option. If the default option is
I, OD, PU
S, O, PU
S, O, PD
Type
Type
Type
I, PU
I, PU
I, PU
I, PU
I, PU
O
Pin #
Pin #
Pin #
12
10
11
29
42
43
44
45
46
8
9
7
TEST CLOCK
This pin has a weak internal pullup.
TEST DATA INPUT
This pin has a weak internal pullup.
TEST OUTPUT
TEST MODE SELECT
This pin has a weak internal pullup.
TEST RESET: Active low asynchronous test reset.
This pin has a weak internal pullup.
RESET: Active Low input that initializes or re-initializes the
DP83848YB. Asserting this pin low for at least 1 s will force a re-
set process to occur. All internal registers will re-initialize to their
default states as specified for each bit in the Register Block sec-
tion. All strap options are re-initialized as well.
See Section 5.5 for detailed description.
The default function of this pin is POWER DOWN.
POWER DOWN: The pin is an active low input in this mode and
should be asserted low to put the device in a Power Down mode.
INTERRUPT: The pin is an open drain output in this mode and will
be asserted low when an interrupt condition occurs. Although the
pin has a weak internal pull-up, some applications may require an
external pull-up resister. Register access is required for the pin to
be used as an interrupt mechanism. See Section 5.5.2 Interrupt
Mechanism for more details on the interrupt mechanisms.
PHY ADDRESS [4:0]: The DP83848YB provides five PHY ad-
dress pins, the state of which are latched into the PHYCTRL reg-
ister at system Hardware-Reset.
The DP83848YB supports PHY Address strapping values 0
(<00000>) through 31 (<11111>). A PHY Address of 0 puts the
part into the MII Isolate Mode. The MII isolate mode must be se-
lected by strapping Phy Address 0; changing to Address 0 by reg-
ister write will not put the Phy in the MII isolate mode. Please refer
to section 2.3 for additional information.
PHYAD0 pin has weak internal pull-up resistor.
PHYAD[4:1] pins have weak internal pull-down resistors.
12
CC
or GND.
Description
Description
Description

Related parts for DP83848YB_08