CAT9554 CATALYST [Catalyst Semiconductor], CAT9554 Datasheet - Page 8

• Manufacturer Part Number: CAT9554
• Description: 8-bit I2C and SMBus I/O Port with Interrupt
• Manufacturer: CATALYST [Catalyst Semiconductor]

CAT9554, CAT9554A
FUNCTIONAL DESCRIPTION
The CAT9554 and CAT9554A general purpose input/
output (GPIO) peripherals provide up to eight I/O ports,
controlled through an I
The CAT9554/54A support the I
sion protocol. This I
that sends data to the bus to be a transmitter and any
device receiving data to be a receiver. The transfer is
controlled by the Master device which generates the
serial clock and all START and STOP conditions for bus
access. The CAT9554/9554A operate as a Slave de-
vice. Both the Master device and Slave device can
operate as either transmitter or receiver, but the Master
device controls which mode is activated.
I
The features of the I
follows:
(1) Data transfer may be initiated only when the bus
(2) During a data transfer, the data line must remain
Doc. No. 25088, Rev. B
2
C Bus Protocol
is not busy.
stable whenever the clock line is high. Any
changes in the data line while the clock line is high
will be interpreted as a START or STOP condition
(Figure 5).
0
Figure 6. CAT9554 Slave Address
1
FIXED
SLAVE ADDRESS
SDA
SCL
0
2
C Bus protocol defines any device
2
2
C bus protocol are defined as
C compatible serial interface
0
PROGRAMMABLE
A2
CONDITION
SELECTABLE
HARDWARE
START
2
C Bus data transmis-
A1
Figure 5. START/STOP Conditions
A0
R/W
8
START and STOP Conditions
The START Condition precedes all commands to the
device, and is defined as a HIGH to LOW transition of
SDA when SCL is HIGH. The CAT9554/9554A monitors
the SDA and SCL lines and will not respond until this
condition is met.
A LOW to HIGH transition of SDA when SCL is HIGH
determines the STOP condition. All operations must end
with a STOP condition.
Device Addressing
After the bus Master sends a START condition, a slave
address byte is required to enable the CAT9554/9554A
for a read or write operation. The four most significant
bits of the slave address are fixed as binary 0100 for the
CAT9554 (Figure 6) and as 0111 for the CAT9554A
(Figure 7). The CAT9554/9554A uses the next three bits
as address bits.
The address bits A
device is accessed from maximum eight devices on the
same bus. These bits must compare to their hardwired
input pins. The 8th bit following the 7-bit slave address
is the R/W bit that specifies whether a read or write
operation is to be performed. When this bit is set to “1”,
a read operation is initiated, and when set to “0”, a write
operation is selected.
Following the START condition and the slave address
byte, the CAT9554/9554A monitors the bus and re-
sponds with an acknowledge (on the SDA line) when its
address matches the transmitted slave address. The
CAT9554/9554A then performs a read or a write opera-
tion depending on the state of the R/W bit.
0
Figure 7. CAT9554A Slave Address
1
FIXED
CONDITION
SLAVE ADDRESS
STOP
2
1
, A
1
and A
1
Characteristics subject to change without notice
PROGRAMMABLE
A2
0
SELECTABLE
HARDWARE
are used to select which
© 2006 by Catalyst Semiconductor, Inc.
A1
A0
R/W