S29PL-J SPANSION [SPANSION], S29PL-J Datasheet - Page 71

• Manufacturer Part Number: S29PL-J
• Description: CMOS 3.0 Volt-only, Simultaneous-Read/Write Flash Memory with Enhanced VersatileIO Control
• Manufacturer: SPANSION [SPANSION]

17. Absolute Maximum Ratings
September 22, 2006 S29PL-J_00_A9
+0.8 V
–0.5 V
–2.0 V
Maximum Negative Overshoot Waveform
Notes:
1. Minimum DC voltage on input or I/O pins is –0.5 V. During voltage transitions, input or I/O pins may overshoot V
2. Minimum DC input voltage on pins A9, OE#, RESET#, and WP#/ACC is –0.5 V. During voltage transitions, A9, OE#, WP#/ACC, and
3. No more than one output may be shorted to ground at a time. Duration of the short circuit should not be greater than one second.
4. Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating only;
Storage Temperature Plastic Packages
Ambient Temperature with Power Applied
Voltage with Respect to Ground
Output Short Circuit Current
20 ns
of up to 20 ns. Maximum DC voltage on input or I/O pins is V
+2.0 V for periods up to 20 ns. See
RESET# may overshoot V
OE#, and RESET# is +12.5 V which may overshoot to +14.0 V for periods up to 20 ns. Maximum DC input voltage on WP#/ACC is +9.5
V which may overshoot to +12.0 V for periods up to 20 ns.
functional operation of the device at these or any other conditions above those indicated in the operational sections of this data sheet is
not implied. Exposure of the device to absolute maximum rating conditions for extended periods may affect device reliability
D a t a
V
A9, OE#, and RESET#
WP#/ACC
All other pins
CC
(Note 1)
(Note 2)
S h e e t
20 ns
(Note 1)
SS
20 ns
(Note 2)
to –2.0 V for periods of up to 20 ns. See
( A d v a n c e
(Note 3)
Figure 17.1 on page
Figure 17.1 Maximum Overshoot Waveforms
S29PL-J
I n f o r m a t i o n )
69.
CC
+2.0 V
+0.5 V
2.0 V
+0.5 V. During voltage transitions, input or I/O pins may overshoot to V
V
V
CC
CC
Figure 17.1 on page
Maximum Positive Overshoot Waveform
20 ns
69. Maximum DC input voltage on pin A9,
–0.5 V to V
–0.5 V to +13.0 V
–0.5 V to +10.5 V
–65°C to +150°C
–65°C to +125°C
–0.5 V to +4.0 V
20 ns
200 mA
CC
SS
+0.5 V
20 ns
to –2.0 V for periods
69
CC