BUS-12-087 FCI-CONNECTOR [FCI connector], BUS-12-087 Datasheet - Page 8

• Manufacturer Part Number: BUS-12-087
• Manufacturer: FCI-CONNECTOR [FCI connector]

NUMBER
TITLE
Ribcage™ II Printed Wiring Board Connector System
Copyright FCI
Form E-3334
Rev F
3.6
BUS-12-087
3.5.5 Capacitance - The capacitance between pairs of adjacent or
Mechanical Characteristics
3.6.1 Contact Retention
3.6.2 Total Mating Force - The total force to mate the terminated
3.6.3 Individual Contact Withdrawal Force - After three
3.6.4 Durability - After 200 mating cycles with mating header,
opposing contacts in an unmated connector shall not exceed 1.0 picofarad when
measured in accordance with MIL-STD-202, Method 305. The following details shall
apply:
(a)
(b)
(c)
3.6.1.1
3.6.1.2
connector with an appropriately populated header consisting of properly configured
(see Figure 2) 0.018 inch formed pins shall be 1.5 to 5.5 ounces times the number of
terminals.
insertions of a properly cleaned and lubricated maximum gage pin, the force required
to withdraw a properly cleaned and lubricated minimum gage, configured as shown in
Figure 4, shall be not less than 10 grams.
the average contact withdrawal force shall be not less than 10 grams and the contact
resistance shall not exceed the value specified in Table I (see paragraph 3.5.2).
TYPE
Test frequency: 100 kilohertz
Special preparation: The connector shall not be terminated because of the type
of printed wiring board and the geometry of its land area will affect this
parameter
Sample size: 20 percent of connector population
PRODUCT SPECIFICATION
unterminated connector shall withstand an axial load of 1.0 pound
average (.7 pound minimum) in the direction of normal pin insertion
without dislodgment.
unterminated connector shall withstand an axial load of .7 pounds
Minimum in the direction of normal contact insertion without
dislodgement.
Receptacle Assembly - Individual contacts in the
Shrouded Header - Individual contacts in the
PDM: Rev:M
STATUS:
PAGE
AUTHORIZED BY
CLASSIFICATION
C. Martinez
Released
8 of 21
UNRESTRICTED
Printed: Nov 28, 2010
REVISION
DATE
27 Feb 07
M
GS-01-001
.