BUS-12-087 FCI-CONNECTOR [FCI connector], BUS-12-087 Datasheet - Page 14

• Manufacturer Part Number: BUS-12-087
• Manufacturer: FCI-CONNECTOR [FCI connector]

4.0
NUMBER
TITLE
Ribcage™ II Printed Wiring Board Connector System
Copyright FCI
Form E-3334
Rev F
PRODUCT QUALIFICATION PROVISIONS
4.1
4.2
4.3
BUS-12-087
Equipment Calibration
Any test equipment and inspection facilities used in the performance of any test shall be maintained
in a calibration system in accordance with MIL-C-45662.
Inspection Conditions
Unless otherwise specified herein, all inspections shall be performed under the following ambient
conditions:
(a)
(b)
(c)
Qualification Inspection
Qualification inspection shall be performed on sample units produced with equipment normally used
in production.
4.3.1 Sample - Qualification inspection shall be performed on
4.3.2 Preparation of Samples
Temperature: 25 +_ 5 o C
Relative humidity: 30 to 80%
Barometric pressure: Local ambient
twenty (24) of the largest population connectors of the type for which qualification
under this specification is desired.
4.3.2.1
4.3.2.2
4.3.2.3
4.3.2.4
TYPE
PRODUCT SPECIFICATION
boards conforming to the applicable requirements of MIL-P-55110 and
MIL-STD-275 shall be prepared as shown in Figure 6 and 7.
the appropriate population and configuration and conforming to the
requirements of Figure 2 shall be prepared.
Sample Mounting - Twelve (12) connectors (one per
board) shall be installed in, and soldered to, the test boards; a flux more
active than that specified in paragraph 3.7.8 (c) may be used to ensure
that the solder joint does not contribute any degradation.
shall be configured as shown in Table V.
Printed Wiring Test Boards - Twelve (12) test
Mating Headers - Twelve (12) mating headers of
Sample Configuration - The various test samples
PDM: Rev:M
STATUS:
PAGE
AUTHORIZED BY
CLASSIFICATION
C. Martinez
Released
14 of 21
UNRESTRICTED
Printed: Nov 28, 2010
REVISION
DATE
27 Feb 07
M
GS-01-001
.