STV-5410-R01 STMICROELECTRONICS [STMicroelectronics], STV-5410-R01 Datasheet - Page 48

no-image

STV-5410-R01

Manufacturer Part Number
STV-5410-R01
Description
Mono and Colour Digital Video CMOS Image Sensors
Manufacturer
STMICROELECTRONICS [STMicroelectronics]
Datasheet
VV5410 & VV6410
8.3.4
All valid video data is contained on active video lines. The pixel data appears as a continuous stream of bytes within the active
lines. The pixel data may be separated from the line header and end-of-line control sequence by a number of ‘blank’ bytes (07
8.3.5
The start of frame line which begins each video field contains no video data but instead contains the contents of the serial
interface register map. Immediately following the SAV sequence there are 2 padding pixels, (see Figure 27), output as blanking
levels, (07
pixels continue to be output until terminated by an end-of-line control sequence. To ensure that no escape/sync characters, (the
reserved FF,FF,00 sequence), appear in the sensor status/configuration information the code 07
interface value.
If a serial interface register location is unused then a default value, the DeviceH register, is output. The read-out order of the
registers is independent of whether the pixel read-out order is shuffled or un-shuffled.
8.3.6
The end of frame line contains no video data. Its sole purpose is to indicate the end of a frame.
8.4
On power-up a sensor will pull all data lines high and these lines will remain high while the device is in the power up default, low
power state. The device is removed from this low power mode by the I2C host writing to sensor register, setup0 [address 10
When the device exits the low power mode it will follow a defined power up sequence, please see Figure 30 for more details.
Upon completion of the power up sequence the sensor will begin streaming video.
8.5
Bit 2 of setup0 register allows the VV5500/VV6500 sensor to be reset to its power-on state via the serial interface. Setting this
“Soft Reset” bit causes all of the serial interface registers including the “Soft Reset” bit to be reset to their default values. This
“Soft Reset” leaves the sensor in low-power mode.
8.6
On power-up the RESETB pin is configured as an active low system reset which has the same effect as a soft reset issued via
the serial interface as described above.
8.7
Bit 5 of the pin mapping register [21] allows the RESETB pin to be re-configured as an active low (edge triggered) system
synchronisation signal which will reset the video timing to the beginning of a field but will NOT reset the serial registers therefore
the host does not have to reconfigure the sensor following a resynchronisation.
48/105
Detection of sensor using data bus state
Resetting the Sensor Via the Serial Interface
Resetting the Sensor Via the RESETB pin
Resynchronising the Sensor Via the RESETB pin configured as SINB
Valid video line timing
Start of frame line timing
End of frame line timing
H
). There will be more blanking codes output after all the serial interface registers have been output . The padding
Commercial in confidence
cd5410-6410f-3-0.fm
Digital Video Interface Format
H
is output after each serial
16
H
].
).

Related parts for STV-5410-R01