A25L40PT-F AMICC [AMIC Technology], A25L40PT-F Datasheet - Page 4

• Manufacturer Part Number: A25L40PT-F
• Description: 4 Mbit, Low Voltage, Serial Flash Memory With 85MHz SPI Bus Interface
• Manufacturer: AMICC [AMIC Technology]

SIGNAL DESCRIPTION
Serial Data Output (Q). This output signal is used to transfer
data serially out of the device. Data is shifted out on the
falling edge of Serial Clock (C).
Serial Data Input (D). This input signal is used to transfer
data serially into the device. It receives instructions,
addresses, and the data to be programmed. Values are
latched on the rising edge of Serial Clock (C).
Serial Clock (C). This input signal provides the timing of the
serial interface. Instructions, addresses, or data present at
Serial Data Input (D) are latched on the rising edge of Serial
Clock (C). Data on Serial Data Output (Q) changes after the
falling edge of Serial Clock (C).
Chip Select (
deselected and Serial Data Output (Q) is at high impedance.
Unless an internal Program, Erase or Write Status Register
cycle is in progress, the device will be in the Standby mode
(this is not the Deep Power-down mode). Driving Chip Select
SPI MODES
These devices can be driven by a microcontroller with its SPI
peripheral running in either of the two following modes:
– CPOL=0, CPHA=0
– CPOL=1, CPHA=1
For these two modes, input data is latched in on the rising
edge of Serial Clock (C), and output data is available from the
PRELIMINARY
S
). When this input signal is High, the device is
(May, 2007, Version 0.4)
3
(
mode.
After Power-up, a falling edge on Chip Select (
prior to the start of any instruction.
Hold (
any
deselecting the device.
During the Hold condition, the Serial Data Output (Q) is high
impedance, and Serial Data Input (D) and Serial Clock (C)
are Don’t Care. To start the Hold condition, the device must
be selected, with Chip Select (
Write Protect (
to freeze the size of the area of memory that is protected
against program or erase instructions (as specified by the
values in the BP2, BP1 and BP0 bits of the Status Register).
falling edge of Serial Clock (C).
The difference between the two modes, as shown in Figure 2,
is the clock polarity when the bus master is in Stand-by mode
and not transferring data:
– C remains at 0 for (CPOL=0, CPHA=0)
– C remains at 1 for (CPOL=1, CPHA=1)
S
) Low enables the device, placing it in the active power
serial
HOLD
). The Hold (
communications
W
). The main purpose of this input signal is
AMIC Technology Corp.
HOLD
S
) driven Low.
with
) signal is used to pause
A25L40P Series
the
device
S
) is required
without