em78p5830aa ELAN Microelectronics Corp, em78p5830aa Datasheet - Page 34

• Manufacturer Part Number: em78p5830aa
• Description: 8-bit Micro-controller 8-bit Micro-controller
• Manufacturer: ELAN Microelectronics Corp

__________________________________________________________________________________________________________________________________________________________________
* This specification is subject to be changed without notice.
(2) Increment Timer Counter ( TMRX: TMR1H/TWR1L or TMR2H/TWR2L )
(3) PWM Period ( PRDX : PRD1 or PRD2 )
(4) PWM Duty Cycle ( DTX: DT1H/ DT1L and DT2H/ DT2L; DTL: DL1H/DL1L and DL2H/DL2L )
(5) PWM Programming Procedures/Steps
(1) Load DTX with the PWM Duty Cycle.
(2) Enable interrupt function by writing IOCF PAFE0, if required.
(3) Set PWMX pin to be output by writing a desired value to IOCC PAGE0.
(4) Load a desired value to R5 PAGE3 with TMRX prescaler value and enable both PWMX and TMRX.
(6) Timer
TMRX are ten-bit clock counters with programmable prescalers. They are designed for the PWM module
as baud rate clock generators. TMRX can be read, written, and cleared at any reset conditions. If
employed, they can be turned down for power saving by setting T1EN bit [PWMCON<4>] or T2EN bit
[PWMCON<5>] to 0.
The PWM period is defined by writing to the PRDX register. When TMRX is equal to PRDX, the
following events occur on the next increment cycle:
• TMRX is cleared.
• The PWMX pin is set to 1.
• The PWM duty cycle is latched from DT1/DT2 to DTL1/DTL2.
< Note > The PWM output will not be set, if the duty cycle is 0;
• The PWMXIF pin is set to 1.
The following formula describes how to calculate the PWM period:
The PWM duty cycle is defined by writing to the DTX register, and is latched from DTX to DLX while
TMRX is cleared. When DLX is equal to TMRX, the PWMX pin is cleared. DTX can be loaded at any
time. However, it cannot be latched into DTL until the current value of DLX is equal to TMRX.
The following formula describes how to calculate the PWM duty cycle:
Load PRDX with the PWM period.
Timer1 (TMR1) and Timer2 (TMR2) (TMRX) are 10-bit clock counters with programmable prescalers,
respectively. They are designed for the PWM module as baud rate clock generators. TMRX can be read,
written, and cleared at any reset conditions.
The figure in the next page shows TMRX block diagram. Each signal and block are described as follows:
Where Fosc is system clock
PERIOD = (PRDX + 1) * 4 * (1/Fosc) * (TMRX prescale value )
Duty Cycle = (DTX) * (1/Fosc) * (TMRX prescale value )
Duty Cycle
Period
Fig.13 The Output Timing of the PWM
DT1 = TMR1
PRD1 = TMR1
32
8-bit Micro-controller
12/1/2004 V1.6
EM785830AA