cn8236 Mindspeed Technologies, cn8236 Datasheet - Page 90
cn8236
Manufacturer Part Number
cn8236
Description
Atm Servicesar Plus With Xbr Traffic Management
Manufacturer
Mindspeed Technologies
Datasheet
1.CN8236.pdf
(443 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
cn8236EBGB
Manufacturer:
VIA
Quantity:
150
Company:
Part Number:
cn8236EBGB
Manufacturer:
CONEXANT
Quantity:
329
- Current page: 90 of 443
- Download datasheet (5Mb)
4.0 Segmentation Coprocessor
4.2 Segmentation Functional Description
4.2.4 ATM PHY Layer Interface
4-12
4.2.4.1 Head-of-Line
Flushing (HoLF)
Once the segmentation coprocessor has formed an ATM cell, the CN8236
transfers the cell to the transmit FIFO buffer. The user chooses the length of this
FIFO buffer, with possible sizes from one to nine cells. The FIFO buffer depth is
programmable, since there is a trade-off between absorbing PCI latency with a
longer FIFO buffer, and introducing greater jitter.
Chapter
FIFO buffer, the cell passes through the FIFO buffer to the PHY layer interface
circuits.
If the SAR is set up as a UTOPIA Master in multi-phy operations, cells are
transmitted to a PHY device after the PHY indicated that it can receive another
cell by asserting its UTOPIA CLAV signal. The UTOPIA Master waits until it
receives the CLAV signal from the PHY device, and therefore blocks the
transmission of all other cells in the transmit FIFO. If this PHY device stops
working, all other PHY devices are blocked. This is called head-of-line blocking.
flush the blocking cell out of the transmit FIFO is incorporated (Head-of-Line
Flushing). This mechanism is enabled by setting the TX_FIFO_FLUSH_EN bit
in the CONFIG1 register.
0 and increased based on the UTOPIA tx_clk. Once the counter reaches the
values TX_CNTR set by the user in the CSR register, the cell is discarded, and the
bit corresponding to the blocking PHY is set in the TX_PORT_STATUS register.
The counter is reset automatically. If any of the eight bits in the TX_STATUS
register is set, TX_DISCARD in HOST_ISTAT1 and LP_ISTAT1 are set. If the
corresponding mask bit EN_TX_DISCARD in HOST_IMASK1 or LP_IMASK1
is set, an interrupt is generated. The TX_DISCARD is cleared once the
TX_STATUS register is read by the host.
NOTE:
Then all cells belonging to this port are discarded or flushed. Ports are disabled by
setting the corresponding bit in the TX_PORT_CTRL register. If a port x is
disabled and a cell pertaining to port x is discarded, bit x in TX_STATUS is not
set, and therefore no interrupt is generated.
65,535 is recommended. For specific DSL applications with variable rate PHY
devices, a value between 50 and 100 is suggested.
In order to avoid head-of-line blocking in the transmit FIFO, a mechanism to
When the UTOPIA Master puts out the address of a PHY, a counter is reset to
The user might decide to disable a specific port on the UTOPIA interface.
For fault-tolerant multi-phy operations, a maximum TX_CNTR value of
The cell discard does not disable the port.
6.0, discusses this trade-off in greater depth. Once sent to the transmit
Mindspeed Technologies
ATM ServiceSAR Plus with xBR Traffic Management
™
Section
6.2.3.3, in the
28236-DSH-001-B
CN8236
Related parts for cn8236
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Framer SDH ATM/POS/STM-1 SONET/STS-3 3.3V 272-Pin BGA
Manufacturer:
Mindspeed Technologies
Part Number:
Description:
RS8234EBGC ATM XBR SAR
Manufacturer:
Mindspeed Technologies
Datasheet:
Part Number:
Description:
ATM SAR 155Mbps 3.3V ABR/CBR/GFR/UBR/VBR 388-Pin BGA
Manufacturer:
Mindspeed Technologies
Datasheet:
Part Number:
Description:
ATM IMA 8.192Mbps 1.8V/3.3V 484-Pin BGA
Manufacturer:
Mindspeed Technologies
Datasheet:
Part Number:
Description:
ATM SAR 622Mbps 3.3V ABR/CBR/GFR/UBR/VBR 456-Pin BGA
Manufacturer:
Mindspeed Technologies
Datasheet:
Part Number:
Description:
RS8234EBGD ATM XBR SAR, ROHS
Manufacturer:
Mindspeed Technologies
Part Number:
Description:
3-PORT T3/E3/STS-1 LIU WITH/ DJAT IC (ROHS)
Manufacturer:
Mindspeed Technologies
Part Number:
Description:
ATM IMA 800Mbps 1.8V/3.3V 256-Pin BGA
Manufacturer:
Mindspeed Technologies
Datasheet:
Part Number:
Description:
Framer SDH ATM/POS/STM-1 SONET/STS-3 3.3V 272-Pin BGA
Manufacturer:
Mindspeed Technologies
Part Number:
Description:
Manufacturer:
Mindspeed Technologies
Datasheet:
Part Number:
Description:
Manufacturer:
Mindspeed Technologies
Datasheet:
Part Number:
Description:
Manufacturer:
Mindspeed Technologies
Datasheet:
Part Number:
Description:
Manufacturer:
Mindspeed Technologies
Datasheet:
Part Number:
Description:
Manufacturer:
Mindspeed Technologies
Datasheet:
Part Number:
Description:
Manufacturer:
Mindspeed Technologies
Datasheet: