ppc440epx Applied Micro Circuits Corporation (AMCC), ppc440epx Datasheet - Page 65

• Manufacturer Part Number: ppc440epx
• Description: Powerpc 440epx Embedded Processor
• Manufacturer: Applied Micro Circuits Corporation (AMCC)

Revision 1.29 – July 22, 2008
Table 8. Signal Functional Description (Sheet 9 of 9)
Notes:
1. Receiver input has hysteresis
2. Must pull up (recommended value is 3kΩ to OV
3. Must pull down (recommended value is 1kΩ)
4. If not used, must pull up (recommended value is 3kΩ to OV
5. If not used, must pull down (recommended value is 1kΩ)
6. Strapping input during reset; pull-up or pull-down required
AMCC Proprietary
Preliminary Data Sheet
Trace Interface
TrcBS0:2
TrcClk
TrcES0:4
TrcTS0:6
Power
V
OV
EOV
SOV
GND
AV
AGND
EAV
EAGND
U1AV
U2AV
U1AGND
U2AGND
DD
DD
DD
DD
DD
DD
DD
DD
Signal Name
Trace branch execution status.
Additional information on trace execution and branch status.
Ground for logic and I/O voltage.
Ground for system PLL voltage (analog).
Ground for Ethernet PLL voltage (analog).
Trace data capture clock, runs at 1/4 the frequency of the
processor.
Trace Execution Status is presented every fourth processor clock
cycle.
+1.5V—Logic voltage.
+3.3V—I/O (except DDR2 SDRAM and Ethernet).
+2.5V—I/O Ethernet.
+1.8V (DDR2) or +2.5V (DDR1)—I/O DDR SDRAM.
+1.5V—Filtered voltage for system PLLs (analog).
+1.5V—Filtered voltage for Ethernet PLLs (analog).
+3.3V—Filtered voltage for USB PLL (analog).
Connect to OV
+3.3V—Filtered voltage for USB PHY (analog).
Connect to OV
Ground for USB PLL (analog) voltage.
Connect to GND.
Ground for USB PHY (analog) voltage.
Connect to GND.
DD
DD
.
.
DD
(EOV
Description
DD
DD
for Ethernet)
440EPx – PPC440EPx Embedded Processor
(EOV
DD
for Ethernet)
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
I/O
I/O
I/O
I/O
O
3.3V tolerant
3.3V tolerant
3.3V tolerant
3.3V tolerant
2.5V CMOS
2.5V CMOS
2.5V CMOS
2.5V CMOS
Type
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
Notes
65