h5an-4dm Omron Corporation, h5an-4dm Datasheet - Page 11

• Manufacturer Part Number: h5an-4dm
• Description: Digital Timer
• Manufacturer: Omron Corporation

Resetting of Type with a Backup Power
Supply Function for Memory Protection
Specifications change in
the middle of operation.
The timer operates
according to the desired
specifications.
The timer operates
according to the
desired specifications.
Purchase of H5AN
reset after power
Selection of
specifications
Was the timer
equipped with
application?
http://www.ia.omron.com/
timer reset?
Is the timer
protection?
memory
Was the
Yes
Yes
Yes
No
No
No
Drawn out the
internal unit from the
case, or switch off
the power to reset
the timer.
The timer operates
according to the
factory-set
specifications.
The timer operates
according to the
previous
specifications.
6. The type without a backup power supply function for memory
The type with a backup power supply function for memory protection
restarts in the status preceding the power failure as shown in (A),
regardless of the duration of the power failure.
7. The type with backup power supply for memory protection
8. When using the timer in operation modes other than N and F
Mounting
A Mounting Fixture is included with the H5AN. Mount the Unit using
the Mounting Fixture so that the Unit is secure and does not move
protection operates as shown below depending on the duration of
the power failure.
(A)
(B)
(C)
incorporates a battery for backup power supply which lasts for
about ten years of normal use, meaning data is retained even
during a power failure lasting ten years. (The battery cannot be
replaced.)
modes (i.e., C, R, K, P, and Q), the control output is available for
the one-shot time only. For this reason, adjust the one-shot time
by rotating the one-shot time adjustment screw on the front panel
(variable within a range to 0.1 to 1 s).
(c)Copyright OMRON Corporation 2008 All Rights Reserved.
Power failure of 0.01 s max.
Power failure of 0.5 s min.
Power failure of 0.01 to 0.5 s.
Note: The timer starts in the initial
Note: The timer starts in the initial
Note: Either (A) or (B)
setting upon power recovery.
setting upon power recovery.
(Y92H-5)
Loosen (to the left) the
screws on the Mounting
Fixture sufficiently and
attach it from the bottom.
Tighten (to the right) the
screws on the Mounting
Fixture completely.
When the screw is
tightened completely,
you will hear it turning
freely in place.
H5AN
11