73k224bl ETC-unknow, 73k224bl Datasheet - Page 6
![no-image](/images/no-image-200.jpg)
73k224bl
Manufacturer Part Number
73k224bl
Description
Single-chip Modem Integrated Hybrid
Manufacturer
ETC-unknow
Datasheet
1.73K224BL.pdf
(33 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
73k224bl-IH
Manufacturer:
TERIDIAN
Quantity:
229
73K224BL
V.22bis/V.22/V.21/Bell 212A/103
Single-Chip Modem w/ Integrated Hybrid
PARALLEL MICROPROCESSOR INTERFACE (continued)
SERIAL MICROPROCESSOR CONTROL INTERFACE MODE
NOTE: The serial control mode is provided by tying ALE high and CS low. In this configuration AD7 becomes
NAME
WR
NAME
AD0-AD2
DATA (AD7)
RD
WR
DATA and AD0, AD1 and AD2 become the register address.
PIN
PIN
5-7
14
12
15
14
TYPE
TYPE
I/O
I
I
I
I
DESCRIPTION
WRITE: A low on this informs the 73K224BL that data is
available on AD0-AD7 for writing into an internal register.
Data is latched on the rising edge of WR . No data is written
unless both WR and the latched CS are low.
DESCRIPTION
REGISTER ADDRESS SELECTION: These lines carry
register addresses and should be valid during any read or
write operation.
SERIAL CONTROL DATA: Data for a read/write operation is
clocked in or out on the falling edge of the EXCLK pin. The
direction of data flow is controlled by the RD pin. RD low
outputs data. RD high inputs data.
READ: A low on this input informs the 73K224BL that data or
status information is being read by the processor. The falling
edge of the RD signal will initiate a read from the addressed
register. The RD signal must continue for eight falling edges
of EXCLK in order to read all eight bits of the referenced
register. Read data is provided LSB first. Data will not be
output unless the RD signal is active.
WRITE: A low on this input informs the 73K224BL that data
or status information has been shifted in through the DATA
pin and is available for writing to an internal register. The
normal procedure for a write is to shift in data LSB first on the
DATA pin for eight consecutive falling edges of EXCLK and
then to pulse WR low. Data is written on the rising edge of
WR .
6