ak4561 AKM Semiconductor, Inc., ak4561 Datasheet - Page 35

• Manufacturer Part Number: ak4561
• Description: 16bit Codec With Built-in Alc And Mic/hp-amp
• Manufacturer: AKM Semiconductor, Inc.

ASAHI KASEI
n LINEOUT
The signals of DAC or Analog Through Mode are gained to +7.5dB (@VA= 2.8V, Vol2-0 bit = “010”) internally, and its
signal is output from LINEOUT. This gain can be changed by VOL2-0 bits.
Output level of LINEOUT is +2dBV and centered HVCM voltage. Load resistance is min. 10k . (Refer to Figure 19)
Power supply voltage for LINEOUT is supplied from HVDD voltage. The supplied HVDD voltage does not change
output level of LINEOUT. But if HVDD voltage is low, a distortion characteristic of LINEOUT is bad.
LOUT1 and ROUT1 outputs are muted by S10 bit. Then LOUT1 and ROUT1 pins is output to HVCM voltage and enter
Power-Save-Mode. (Refer to Figure 20). When PM7 bit is “0”, LOUT1 and ROUT1 pins become Power-Down-Mode
and output signal is Hi-z. (Refer to Figure 21)
When PD pin changes from “L” to “H” after power-up, LOUT1 and ROUT1 pins become Power-Save-Mode. In
Power-Save-Mode, LOUT1 and ROUT1 pins gradually become HVCM voltage via an internal resistor (R1: typ.200k )
from Hi-z to decrease a pop noise. And when Power OFF, the pop noise can be decreased by controlling via Power-
Save-Mode.
Rev. 0.9
Figure 21. LINEOUT Power-Down-Mode
Figure 20. LINEOUT Power-Save-Mode
Figure 19. LINEOUT Normal Operation
LOUT
LOUT
LOUT
AKM CONFIDENTIAL
-
+
-
+
-
+
LOUT
LOUT
LOUT
LOUT
LOUT
LOUT
- 35 -
LOUT
LOUT
LOUT
R1
R1
R1
LOUTP
LOUTP
LOUTP
LOUT1/ROUT1
LOUT1/ROUT1
LOUT1/ROUT1
C1
C1
C1
R2
R2
R2
[AK4561]
2000/09