mb95f108bspfv Fujitsu Microelectronics, Inc., mb95f108bspfv Datasheet - Page 4

• Manufacturer Part Number: mb95f108bspfv
• Description: 8-bit Proprietary Microcontrollers
• Manufacturer: Fujitsu Microelectronics, Inc.

4
MB95100B Series
(Continued)
*1 : Specify clock mode when ordering MASK ROM.
*2 : MB95F108BS/MB95D108BS is single clock and MB95F108BW/MB95D108BW is dual clock.
*3 : This device is under development.
*4 : For details of option, refer to “I MASK OPTION”.
*5 : MB95D108BS/D108BW/R107B contain 4 general-purpose I/O ports for N-ch open drain. Port number other
*6 : Embedded Algorithm is a trade mark of Advanced Micro Devices Inc.
Note : Part number of the evaluation products in MB95100B series is MB95FV100D-101. When using it, the MCU
Parameter
Standby mode
than MB95D108BS/D108BW/R107B has 6 general-purpose I/O ports for N-ch open drain.
16-bit reload timer
8/16-bit compound
timer (2 channels)
16-bit PPG
(2 channels)
8/16-bit PPG
(2 channels)
Watch counter
(for dual clock
product)
Watch prescaler
(for dual clock
product)
External interrupt
(12 channels)
Flash memory
board (MB2146-301A) is required.
Part number
Two clock modes and two counter operating modes can be selected. Square wave form
output
Count clock : 7 internal clocks and external clock can be selected.
Counter operating mode : reload mode or one-shot mode can be selected.
Each channel of the timer can be used as “8-bit timer × 2 channels” or “16-bit timer × 1
channel”.
Built-in timer function, PWC function, PWM function, capture function and square
wave form output
Count clock : 7 internal clocks and external clock can be selected.
PWM mode or one-shot mode can be selected.
Counter operating clock : Eight selectable clock sources
Support for external trigger start
Each channel of the PPG can be used as
channel
Counter operating clock : Eight selectable clock sources
Count clock : Four selectable clock sources (125 ms, 250 ms, 500 ms, or 1 s)
Counter value can be set from 0 to 63. (Capable of counting for 1 minute when selecting
clock source 1 second and setting counter value to 60)
4 selectable interval times (125 ms, 250 ms, 500 ms, or 1 s)
Interrupt by edge detection (rising, falling, or both edges can be selected.)
Can be used to recover from standby modes.
Supports automatic programming, Embedded Algorithm
Write/Erase/Erase-Suspend/Resume commands
A flag indicating completion of the algorithm
Number of write/erase cycles (Minimum) : 10000 times
Data retention time : 20 years
Erase can be performed on each block
Boot block configuration
Block protection with external programming voltage
Flash Security Feature for protecting the content of the Flash
Sleep, stop, watch (for dual clock product), and timebase timer
MB95107B
”
.
MB95F108BS/
MB95F108BW
“
8-bit PPG
MB95R107B*
×
2 channels
TM
*
6
3
”
or
MB95D108BS/
MB95D108BW
“
16-bit PPG
×
1