sak-xc888clm-8ffa Infineon Technologies Corporation, sak-xc888clm-8ffa Datasheet - Page 94

• Manufacturer Part Number: sak-xc888clm-8ffa
• Description: High Performance 8-bit Microcontroller With On-chip Flash Memory And Can
• Manufacturer: Infineon Technologies Corporation

3.19
The On-Chip Debug Support (OCDS) provides the basic functionality required for the
software development and debugging of XC800-based systems.
The OCDS design is based on these principles:
• use the built-in debug functionality of the XC800 Core
• add a minimum of hardware overhead
• provide support for most of the operations by a Monitor Program
• use standard interfaces to communicate with the Host (a Debugger)
Features:
• Set breakpoints on instruction address and on address range within the Program
• Set breakpoints on internal RAM address range
• Support unlimited software breakpoints in Flash/RAM code region
• Process external breaks via JTAG and upon activating a dedicated pin
• Step through the program code
The OCDS functional blocks are shown in
block at the center of OCDS system brings together control signals and supports the
overall functionality. The MMC communicates with the XC800 Core, primarily via the
Debug Interface, and also receives reset and clock signals.
After processing memory address and control signals from the core, the MMC provides
proper access to the dedicated extra-memories: a Monitor ROM (holding the code) and
a Monitor RAM (for work-data and Monitor-stack).
The OCDS system is accessed through the JTAG
exclusively for testing and debugging activities and is not normally used in an
application. The dedicated MBC pin is used for external configuration and debugging
control.
Note: All the debug functionality described here can normally be used only after XC886/
1)
Data Sheet
Prelimary
Memory
The pins of the JTAG port can be assigned to either the primary port (Port 0) or either of the secondary ports
(Ports 1 and 2/Port 5).
User must set the JTAG pins (TCK and TDI) as input during connection with the OCDS system.
888 has been started in OCDS mode.
On-Chip Debug Support
Figure
90
37. The Monitor Mode Control (MMC)
1)
, which is an interface dedicated
Functional Description
XC886/888CLM
V0.1, 2006-02