sak-xc888clm-8ffa Infineon Technologies Corporation, sak-xc888clm-8ffa Datasheet - Page 84

• Manufacturer Part Number: sak-xc888clm-8ffa
• Description: High Performance 8-bit Microcontroller With On-chip Flash Memory And Can
• Manufacturer: Infineon Technologies Corporation

The header consists of a break and synch pattern followed by an identifier. Among these
three fields, only the break pattern cannot be transmitted as a normal 8-bit UART data.
The break must contain a dominant value of 13 bits or more to ensure proper
synchronization of slave nodes.
In the LIN communication, a slave task is required to be synchronized at the beginning
of the protected identifier field of frame. For this purpose, every frame starts with a
sequence consisting of a break field followed by a synch byte field. This sequence is
unique and provides enough information for any slave task to detect the beginning of a
new frame and be synchronized at the start of the identifier field.
Upon entering LIN communication, a connection is established and the transfer speed
(baud rate) of the serial communication partner (host) is automatically synchronized in
the following steps:
Note: Re-synchronization and setup of baud rate are always done for every Master
Data Sheet
Prelimary
STEP 1: Initialize interface for reception and timer for baud rate measurement
STEP 2: Wait for an incoming LIN frame from host
STEP 3: Synchronize the baud rate to the host
STEP 4: Enter for Master Request Frame or for Slave Response Frame
Request Header or Slave Response Header LIN frame.
80
Functional Description
XC886/888CLM
V0.1, 2006-02